EN
3
1. FOCUS: Focus the projected image
2. Adaptor socket
3. Battery compartment
4. EU / UK: Select clock reception
5. PROJECTION AUTO / CLOCK / OFF: Select the
projection mode
6. 180° ROTATION: Rotate projection image by 180°
degrees
7. SET ALARM: Set alarm
8. SET CLOCK: Enter clock setting mode
9. °C / °F: Select temperature unit
10.
/ : Increase / decrease settings; activate /
deactivate clock reception signal
11.
RESET: Reset unit to default settings
REMOTE SENSOR
1. LED status indicator
2. Wall mount hole
3. Battery compartment
4. RESET hole
5. CHANNEL switch
GETTING STARTED
POWER SUPPLY
Batteries serve as back up. For continuous use of
projector and backlight, always plug in the adapter
socket. Make sure the socket outlet is easily accessible
to the unit.
To insert batteries:
1. Remove the battery compartment and insert the
batteries, matching the polarities.
2. Press
RESET after each battery change.
indicates main unit batteries are low.
REMOTE SENSOR
To set up the sensor:
1. Open the battery compartment.
2. Select a channel then press RESET.
3. Close the battery door.
4. Place the sensor within 30 m (98 ft) of the main unit
using the table stand or wall mount .
TIP The transmission range may vary depending on
many factors. You may need to experiment with various
locations to get the best results.
