796431
2
Zoom out
Zoom in
Previous page
1/5
Next page
EN
Talking Blood Pressure Monitor
Model:
BPW810N
USER MANUAL
INTRODUCTION
Thank you for selecting the Oregon Scienti c
TM
Thank you for selecting the Oregon Scienti c
Thank you for selecting the Oregon Scienti c
TalkingWrist
Type Blood Pressure Monitor (BPW810N). The (BPW810N)
features voice announcement and playback of blood
pressure measurements for added convenience and has been
designed to provide you with many years of reliable service.
The unit can help you measure and track the following metrics:
Systolic pressure
Diastolic pressure
Mean arterial pressure
Pulse rate
Historic record of up to 30 measurements per user
(maximum 2 users)
Readings taken by the blood pressure monitor are
equivalent to those obtained by a trained observer using
the cuff and stethoscope auscultation method. Clinical
performance were successfully done against ANSI/
AAMI SP10 and international protocol, and the B.H.S.
(British Hypertension Society) has rated this product
“recommended for clinical and home use”, the highest
grading available for blood pressure monitors.
Please refer to BHS website http://www.bhsoc.org/bp_
monitors/automatic_wrist.stm
This manual contains important safety and care information,
and provides step-by-step instructions for using the product.
Read the manual thoroughly before using the product.
KEY FEATURES
FRONT VIEW
1. TALK / VOLUME button
2. LCD
3. ON / OFF button
4. Speaker
5. USER 1 / UP ARROW button
6. USER 2 / DOWN ARROW button
7. SET button
REAR VIEW
1. Wrist cuff
2. Battery compartment
LCD SYMBOLS
SAFETY AND CARE INSTRUCTIONS
SAFETY PRECAUTIONS
Please observe the following safety precautions when
setting up and using your blood pressure monitor.
This device is intended for adult use only.
This device is intended for non-invasive measuring
and monitoring of arterial blood pressure. It is not
intended for use on extremities other than the wrist
or for functions other than obtaining a blood pressure
measurement.
Do not confuse self-monitoring with self-diagnosis.
This unit allows you to monitor your blood pressure.
Do not begin or end medical treatment based solely on
the measurements of this device. Consult a physician
for treatment advice.
If you are taking medication, consult your physician
to determine the most appropriate time to measure
your blood pressure. Never change a prescribed
medication without consulting your physician.
This unit is not suitable for continuous monitoring
during medical emergencies or operations.
If the cuff pressure exceeds 40 kPa (300 mmHg),
the unit will automatically de ate. Should the cuff not
de ate when pressures exceeds 40 kPa (300mmHg),
detach the cuff from the wrist and press the button
to stop in ation.
To avoid measurement errors, carefully read this
manual before using the product.
CARING FOR YOUR BLOOD PRESSURE MONITOR
To ensure you receive the maximum bene t from using
this product, please observe the following care guidelines.
When not in use, store the unit in a dry place away
from direct sunlight.
User Shows which user
pro le (1 or 2 is
being displayed)
Memory If “MEM” shows,
the displayed
measurement value
is from the memory
and not necessarily
from the last reading
SYMBOL DESCRIPTION EXPLANATION
Systolic pressure The highest blood
pressure measured
Diastolic pressure The lowest blood
pressure measured
Time (hour: minutes)
Current time
Mean arterial
pressure
Average blood
pressure measured
(see “What is Mean
Arterial Pressure
(MAP)?” for more
information)
Pulse Pulse rate per
minute
Weak battery Batteries are low and
need to be replaced
In ating Unit is in ating
with air to obtain
the needed level of
pressure
De ating Wrist cuff air is
exhausting or
de ating
Millimeter(s) of
mercury
Measurement unit
for blood pressure
Kilopascal Measurement unit
for blood pressure
Voice activation Voice announcing
your blood pressure
measured
Do not immerse the unit in water. If it comes in contact
with water, dry it immediately with a soft lint-free cloth.
Use a soft, slightly moistened cloth to wipe off the unit
and cuff. Do not use abrasive or corrosive cleaning
agents, as these may cause damage.
Remove the batteries whenever you are planning to
store the unit for a long period of time.
When replacing batteries, use new batteries as
speci ed in this user manual. Do not mix new and old
batteries.
Do not place objects such as stickers on the wrist cuff
or unit, as these may impair the measurement.
Do not subject the unit to excessive force, shock, dust,
temperature changes, or humidity. Such treatment
may result in malfunction, a shorter electronic life
span, damaged batteries, or distorted parts.
Do not tamper with the internal components. Doing
so will terminate the product warranty and may cause
damage.
The unit contains no user- serviceable parts.
If you no longer need to use this product, protect the
environment by bringing it to your dealer or designated
collection point for proper disposal.
ABOUT BLOOD PRESSURE
What is blood pressure?
Blood pressure is the force generated by the blood against the
walls of arteries during cardiac contraction and relaxation
(e.g., the pumping action of the heart).
What are systolic pressure and diastolic pressure?
When ventricles contract and pump blood out of the heart,
blood pressure reaches its maximum value. This highest
pressure in the cycle is known as systolic pressure. When
the heart relaxes between heartbeats, the lowest blood
pressure is diastolic pressure.
What is mean arterial pressure (MAP)?
The mean arterial pressure (MAP) is the average
pressure that forces blood through the arteries. It is not
the average of the systolic and diastolic blood pressure;
rather, MAP corresponds to a state of balance between the
compressive and expansive forces acting on the arterial
wall when there is no distension outward or inward. MAP is
an excellent way to evaluate the stress on the walls of your
blood vessels, and can be used to evaluate excessive load
on the cardiovascular system. Show your MAP history to
your doctor to provide additional information that may help
him or her understand your situation.
Why measure your blood pressure?
Blood pressure measurement can highly re ect one’s
health condition. High blood pressure is potentially linked
to serious illnesses such as stroke, heart disease and
kidney failure.
Since there is no symptom most of the time, many
hypertensive people do not realize they are at risk until
their health is seriously threatened.
What is the standard blood pressure classi cation?
Figure 3 illustrates the blood Pressure classi cation made
by World Health Organization (WHO) and International
Society of Hypertension (ISH) in 1999.
Reference material: 1999 World Health Organization-
International Society of Hypertension Guidelines for the
management of hypertension, Journal of Hypertension,
1999, 17(2): 151-183.
NOTE
Blood pressure is considered high when either the
diastolic or systolic blood pressure value exceeds the
normal range. When a patient’s systolic and diastolic
blood pressures fall into different categories, the
higher category should apply.
Only a physician can tell you your normal blood
pressure range and the point at which you are at risk.
Why does my blood pressure uctuate throughout the day?
Individual blood pressure varies greatly both on a daily and
a seasonal or temperature basis. These variations may be
more pronounced in hypertensive patients. Normally the
blood pressure rises while at work and is at its lowest
during sleep.
The graph below illustrates the variations over a single day
with measurement taken every 5 minutes. The thick line
represents sleep time. The rises in blood pressure at 4PM
(A in the graph) and 12AM (Bin the graph) correspond to
an attack of pain and sexual intercourse (Beven, Honour &
Stott, Clin. Sci. 36:329, 1969).
HOW THE BLOOD PRESSURE MONITOR WORKS
This product uses the Oscillometric Measuring method to
detect your blood pressure. Before every measurement,
the unit establishes a “zero pressure”equivalent to the air
pressure.
Then it starts in ating the wrist cuff to 180mmHg or higher
until it senses that it has blocked your blood in the artery.
After that, the de ation process starts, during which time
the unit detects pressure oscillations generated by beat-
to-beat pulsatile, which is used to determine the systolic,
mean and diastolic pressure, and also your pulse rate.
Any motion during this period will result in an incorrect
measurement. After all readings are determined and
displayed on the LCD, the measurement is nished and
the wrist cuff automatically de ates.
GETTING STARTED
INSTALLING AND REPLACING THE BATTERIES
1. Slide off the battery cover.
2. Install the batteries by matching the correct polarity, as
shown below. Always use the correct battery type (2
alkaline LR03 AAA-size).
3. Replace the cover.
NOTE Replace the batteries whenever the weak battery
mark shows, the display is dim, or the display does not
illuminate when the power is on. Replace all the batteries
at the same time - it is dangerous to mix old and new
batteries.
Contact your local waste disposal authority for instructions
on how to dispose of used batteries. Used batteries can be
harmful to the environment, and should not be thrown out
with household trash.
SETTING DATE, TIME AND MEASUREMENT UNITS
It is important to set the clock before using your blood
pressure monitor, so that a time stamp can be assigned to
each record that is stored in the memory.
1. When the unit is off, press and hold SET for 2 seconds
to enter the setting mode.
2. The setting order is as follows: 12/24 hour format,
hour, minute, year, month/day or day / month format,
month, date, and measurement unit (kPa or mmHg).
3. Press or
or
to increase / decrease a value or change the
to increase / decrease a value or change the
setting.
4. Press SET to accept the change and switch to the next
setting.
5. When you are nished, press to exit the setup menu.
to exit the setup menu.
POSITIONING THE WRIST CUFF
It is important to properly position the wrist cuff to ensure
that you receive an accurate reading.
1. Remove all accessories (watch, bracelet, etc.) from
your left wrist. If your physician has diagnosed you with
poor circulation in your left arm, use your right wrist.
2. Roll or push up your sleeve to expose the skin.
3. Apply the cuff to your left wrist with your palm facing up.
4. Position the edge of the cuff about 0.4 inches (1cm)
from the bottom of your palm.
5. Fasten the wrist cuff around your wrist, leaving no
extra room between the cuff and your skin. If the cuff
is too loose, the measurement will not be accurate.
NOTE Graphics may not exactly match product.
VOICE PLAYBACK OF BLOOD PRESSURE
MEASUREMENTS
The BPW810N features voice playback during and after blood
pressure measurement results, as well as general
instructions to help you prepare for taking measurements.
When the unit has nished taking your measurement,
your blood pressure readings, pulse and blood pressure
classi cation are announced.
If you want to repeat the announcement, simply press
TALK / VOLUME.
Anytime you recall a measurement record from memory,
it will also be announced. Press TALK / VOLUME if you
need to repeat the playback of any record.
VOLUME CONTROL
To adjust the volume level:
1. Press and hold TALK / VOLUME until volume level
ashes on the LCD.
2. Press TALK / VOLUME to adjust volume level.
3. Press when you have nished adjusting the volume.
when you have nished adjusting the volume.
NOTE When volume level 0 is selected, the unit is on mute
and you will not hear any voice messages announced.
TAKING A BLOOD PRESSURE MEASUREMENT
You can choose to take your blood pressure while sitting or lying
down. Below are some helpful tips for taking a measurement:
Be sure to set the clock before taking your rst
measurement, or whenever you replace the batteries,
so that the date and time are stored in the memory
with your history. For instructions, refer to "Setting date,
time and measurement units" section.
It is important to relax when taking your blood pressure.
Try to take a 15-minute rest before you begin.
Do not lean backward or bend your wrist inward while
taking a measurement.
Avoid talking or moving your ngers and hand while
taking a measurement. Rapid movements or other
1 2
(MUTE) (VOLUME IS
LOW)
(VOLUME IS
HIGH)
kP
a
Grade 3 hypertension(severe)
Grade 2 hypertension(moderate)
Systolic blood pressure (mmHg)
Grade 1 hypertension(mild)
Subgroup: borderline
High-normal Blood Pressure
)gHmm(erusserpdoolbcilotsaiD
Normal Blood Pressure
Optimal Blood
Pressure
120
80
85
90
95
100
110
130 140 150 160 180
1
2
3
5
4
6
7
Consult your physician to obtain these values. If the
measurements taken with these products fall outside
the range, consult your physician.
2


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Oregon Scientific BPW810N at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Oregon Scientific BPW810N in the language / languages: English as an attachment in your email.

The manual is 1.84 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info