461271
6
Zoom out
Zoom in
Previous page
1/9
Next page
EN
6
SET UNIT AND ALTITUDE
You can set the barometric unit of measurement (mb /
hPa or inHg) and altitude. Doing this allows the product
to take more accurate barometric measurements.
1. Press PRESSURE to select the unit of
measurement: mb / hPa or inHg.
2. Press and hold PRESSURE for 2 seconds.
3. Select the altitude (-100 to 2500 metres) in
increments of 10). Press
or to change the
setting. Press PRESSURE to confirm.
WEATHER FORECAST
This product forecasts the next 12 to 24 hours of weather
within a 30-50 km (19-31 mile) radius with 70 to 75
percent accuracy. The weather forecast is always
displayed.
TEMPERATURE AND HUMIDITY
This product can display current, minimum, and maximum
temperatures and humidity percentage information
collected by the remote sensors and main (indoor) unit.
Outdoor data is collected and displayed every 40 seconds.
Indoor data is collected and displayed every 10 seconds.
SELECT TEMPERATURE UNIT
Slide the
°C / °F switch into the desired location. The
switch is located on the front button panel. The setting for
the main unit overrides the remote sensor setting.
SELECT CHANNEL NUMBER
Press CHANNEL to switch between sensors 1-3.
The icon shows the selected sensor.
To auto-scan between sensors, press and hold
CHANNEL for 2 seconds. Each sensor's data will be
displayed for 3 seconds. To end auto-scan, press
CHANNEL or MEMORY.
NOTE If you use a sensor that collects only temperature
data, humidity will not be shown.
NOTE For more information on the sensor see "Remote
Sensor THGR122NX" Section.
SWITCH CLOCK DISPLAY
Press MODE to toggle between Clock with Seconds and
Clock with Weekday display.
ALARM
This product is equipped with a 2-minute crescendo
alarm.
VIEW ALARM SETTINGS
Press . The alarm time and alarm status will show
in the Clock Area.
SET ALARM
1. Press to switch to alarm display.
2. Press and hold again for 2 seconds. The alarm
settings will blink.
3. Select the hour and minute. Press
or to change
settings. Press to confirm.
ACTIVATE ALARM
Press to activate or deactivate the alarm. shows in
the Clock / Alarm Area when the alarm is activated.
SILENCE ALARM
When the alarm time is reached, the crescendo alarm
will sound for 2 minutes. To silence the alarm:
•Press SNOOZE / LIGHT to silence it for 8 minutes.
OR
•Press any key except SNOOZE to mute the alarm
and activate it again after 24 hours.
If no button is pressed, the alarm will automatically
silence after 2 minutes. It will then sound again after 8
minutes.
BAROMETER
This product tracks barometric pressure changes over
the past 24 hours to provide the weather forecast (X)
and a trend line showing the direction of barometric
change. Barometric changes are measured by the main
(indoor) unit.
BAROMETRIC TREND
TREND DESCRIPTION
Rising
Steady
Falling
SUNNY PARTLY CLOUDY RAINY
CLOUDY
Kinetic-
wave
Icon
Designat- Indoor Remote Remote Remote
ed Display Display Display Display
Display Channel 1 Channel 2 Channel 3
BAR629HG(EN)2 26/7/04, 12:41 am6
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Oregon Scientific BAR629HGU at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Oregon Scientific BAR629HGU in the language / languages: English as an attachment in your email.

The manual is 0,3 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Oregon Scientific BAR629HGU

Oregon Scientific BAR629HGU User Manual - German - 9 pages

Oregon Scientific BAR629HGU User Manual - Dutch - 9 pages

Oregon Scientific BAR629HGU User Manual - French - 9 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info