640534

Oregon 511A Manual

9
Zoom out
Zoom in
Previous page
1/19
Next page
0
D. Mounting Shield and Arbor Guard
1. Remove shield bolt from motor/head unit.
2. Insert allen-head bolt #7 and washer #8
through shield guard assembly and tighten
to motor/head assembly using the small
4.5 mm allen wrench #12 (see Figure 6).
3. To install arbor guard, insert the bolt
through the arbor and shield guard
assembly and mount onto motor/head
unit (see Figure 7).
E. Selecting and Mounting the Grinding Wheel:
1. For the appropriate size grinding wheel
see table 2 on page 15.
2. Make sure that the grinding wheel is in
perfect condition. Hang the wheel by the
center hole and tap it lightly with a metal
object on one side near the perimeter.
If a flat tone is heard it may be cracked
or broken. Do not use! (see Figure 8).
3.Position the desired grinding wheel inside
the shield guard assembly onto the motor
flange and insert arbor bolt, with washer,
through the wheel center hole into motor
shaft. Tighten the arbor bolt, with the large
5.5mm Allen wrench #11 (provided with this
unit), to a snug fit (see Figures 9 and 10).
Do not over-tighten this bolt, as doing so
may cause damage to the wheel, rendering
it unusable.
ASSEMBLY INSTRUCTIONS
7
Figure 7
Figure 6
Figure 8
Figure 9
Figure 10
… 9 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Oregon 511A at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Oregon 511A in the language / languages: English as an attachment in your email.

The manual is 1,4 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info