161516
26
Zoom out
Zoom in
Previous page
1/28
Next page
26
Troubleshooting
If you have any trouble using the DX-7355, look for a solution in this section.
Can’t turn on the DX-7355.
Make sure that the power cord is properly plugged into the wall outlet (page 15).
Unplug the power cord from the wall outlet, wait five seconds or more, then plug it in again.
There’s no sound.
The DX-7355 is not connected properly. Check all connections and correct as necessary.
The wrong input source is selected on your amplifier. Check your amplifier’s input source setting. Refer to your
amplifier’s manual.
Can’t play a CD.
The disc is upside down. Load the disc with the label-side facing up (page 16).
The disc is dirty. Remove the disc and clean it (page 11).
Condensation has formed inside the DX-7355. Remove the disc and leave the DX-7355 turned on for several hours
until the condensation has evaporated.
The disc is nonstandard. See “Supported Discs” on page 11.
The CD-R/RW disc is nonstandard. See “Supported Discs” on page 11.
CD playback skips.
Install the DX-7355 somewhere free of vibration.
The disc is dirty. Remove the disc and clean it (page 12).
The disc is very scratched. Replace the disc.
Can’t enter track numbers for memory playback.
No such track on the CD. Enter another number (page 22).
It takes a long time to locate certain tracks.
The disc is dirty. Remove the disc and clean it (page 12).
The disc is very scratched. Replace the disc.
Can’t find a SETUP menu in need.
If any track has been selected even when the DX-7355 is stopped, you must place it into the full stop state by pressing
the [ ] button before you can view all the SETUP menus.
The remote controller does not work.
There are no batteries in the remote controller. Install new batteries (page 10).
The batteries are flat. Replace with new batteries (page 10).
The batteries are installed incorrectly. Check the batteries and correct as necessary (page 10).
You’re not pointing the remote controller at the DX-7355’s remote sensor. Point the remote controller at the
DX-7355’s remote sensor (page 10).
You’re too far away from the DX-7355. Use the remote controller closer to the DX-7355 (page 10). The remote
controller has a range of approximately 5 meters (16 ft.).
A strong light source is interfering with the DX-7355’s remote sensor. Make sure that the DX-7355 is not subjected
to direct sunshine or inverter-type fluorescent lights. Relocate if necessary.
If the DX-7355 is installed in a cabinet with colored glass doors, the remote controller may not work reliably when
the doors are closed. Open the doors, or use a cabinet without colored glass.
If you can’t resolve the issue yourself, try resetting the DX-7355 before contacting your Onkyo dealer.
To reset the DX-7355 to its factory defaults, turn it on and, while holding down the
[ ] button, press the [REPEAT] button. “CLEAR” will appear on the display.
Note that resetting the DX-7355 will delete your custom settings.
Power
Audio
CD
SETUP
Remote Controller
26


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Onkyo dx-7355 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Onkyo dx-7355 in the language / languages: English as an attachment in your email.

The manual is 0,79 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Onkyo dx-7355

Onkyo dx-7355 User Manual - German, Dutch - 80 pages

Onkyo dx-7355 User Manual - French, Italian - 80 pages

Onkyo dx-7355 User Manual - Swedish - 80 pages

Onkyo dx-7355 User Manual - Spanish - 80 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info