Chapter 6 Child’s bicycle seat OKBABY ORION Page 73
Instructions for use and assembly LIB003R03 Edition: 05-2005
- the child’s seat does not cause any
particular difficulties whilst pedalling.
If any of these situations arises, refer to
illustrations 4 and 5 on the previous page.
Illustration 4:
Loosen the fixing nuts under the seat and
move it frontward or backwards as
required, tightening the nuts again.
Illustration 5:
Compatibly with the height of the crossbar
of your bicycle, you can also move the
fixing block upwards or downwards,
loosening the four screws (9), and then
tighten them again after having found the
most satisfactory position. Tighten the
screws (9) gradually and evenly until the
fixing block no longer rotates around the
frame. Avoid excessive tightening of the
screws.
Illustration 7:
To extract the child’s seat from the fixing
block, push the two safety springs 15
inwards whilst sliding the support arm out
of the holes.
DANGER! Always check that the
bicycle handlebar does not remain caught
in the child’s seat whilst steering.
Illustration 8:
Insert the footrests (4) with the respective
belt in the relative housings.
ATTENTION! Take care to insert
the correct footrest in its housing, bearing
in mind that there is one footrest for the
right foot and one for the left foot.
Instructions for use and assembly LIB003R03 Edition: 05-2005
Chapter 6 Child’s bicycle seat OKBABY ORION Page 72
Illustration 4:
After having positioned the support arm,
with the screws loose, in one of the three
possible positions (usually the
intermediate one is the most commonly
used) tighten the nuts with the wrench
(14) supplied until completely fixed.
Illustration 5:
Choose the plastic reducers (11) suitable
to the diameter of the crossbar of your
bicycle. Insert the reducers (11) into the
fixing block (7) and the fixing counter-
block (8). Assemble the fixing block (7)
with the fixing counter-block (8) using the
four screws (9) with their respective
washers and nuts. Leave the screws (9)
slightly loose in order to be able to
proceed with any adjustments in height
and in rotation.
The support must only be placed in the
direction of travel as shown in
illustration 6.
Illustration 6:
Take the seat and insert the ends of the
support arm (6). in the two holes 16 on
the fixing block. Check that the support
arm is in place by means of the special
stops on it and that the two safety springs
15, on the two sides of the fixing block,
are inserted in the appropriate housings
on the support arm. At this stage, check
that:
- the handlebar interferes as little as
possible with the seat and allows you to
steer normally;
11
78
9
15
16
4
14
11
15 15
ENGLISH
ENGLISH
