783003
29
Zoom out
Zoom in
Previous page
1/32
Next page
29
TROUBLESHOOTING
If there are any problems during operation, please refer to the following table. If problems cannot be
solved as indicated under Solution, please contact your manufacturer.
Problem Possible cause Solution
product does not
start
not connected to power supply connect to power supply
power cord or plug is defective check by a specialist
other electrical defect to the product check by a specialist
error occurred see protection and error codes
remote control faulty see below
remote control not
working
batteries exhausted replace batteries
product out of range or signals
disrupted by obstacle
move the remote control closer and
clear obstructions
other electrical defect to the remote
control
check by a specialist
timer not working implausible, contradictory or wrong
time set
check timer setting
unsatisfactory
cooling
nearby heat source hinders cooling
process
relocate product or remove heat
source
ventilation insucient ensure surrounding clearance
open window(s) or door(s) in the
room
close window(s) / door(s)
exhaust hose not properly connected
or blocked
connect properly or check for and
remove blockage
air lter(s) blocked clean air lter(s)
temperature set too high regulate the temperature controller
noise product is not levelled level the product
product contacts obstacle remove obstacle
Note:
Murmur of water is heard when the product is operating. It is a normal sound of the coolant circulating
in the system.
Protection and error codes
Code Cause Solution
P1 internal water tank full drain through lower outlet
E1 room temperature sensor error switch the product into standby, unplug and re-plug
E2 evaporator temperature sensor error switch the product into standby, unplug and re-plug
E4 control panel communication error switch the product into standby, unplug and re-plug
Note:
Contact the service centre if errors occur reputably.
IM_OAC2221_161201_V04_HR.indb 29 1/12/16 4:31 PM
29


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for OK OAC 2221 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of OK OAC 2221 in the language / languages: English, German as an attachment in your email.

The manual is 4.52 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info