703090
3
Zoom out
Zoom in
Previous page
1/59
Next page
32
Make sure the blade base is securely screwed onto the Short Cup or Batchbowl
before placing it on the Power Base.
• Never leave the NutriBullet Baby unattended while it is in use.
Never run the NutriBullet Baby without food or liquid contents in the Cup or Batch
Bowl.
• Close supervision is necessary when any appliance is used near children.
To reduce the risk of injury, be certain that the blade is completely and firmly
screwed on to the Short Cup or Batchbowl container before operating the appliance.
• Do not use the NutriBullet Baby outdoors.
• Blades are sharp. Handle carefully.
Check gasket to make sure it is completely seated in the Baby Blend Blade or
Milling Blade base before each use.
• Do not attempt to defeat the cover interlock mechanism.
Do not use the Date-Dial Storage Cups to freeze foods. Use the Easy-pop Batch Tray
to freeze foods.
• Do not fill the date dial storage cups more than 2/3 full.
Do Not fill the batch tray freezer storage containers more than 2/3 full prior to freezing.
BATCHBOWL SAFEGUARDS
• Always operate the Batchbowl with the Lid firmly in place.
Never blend carbonated beverages. Released gases can cause pressure to build up
and the container to burst, resulting in possible injury.
When blending hot liquids, remove center piece of two-piece cover.
Always ensure that the two-piece cover is firmly in place before operating the
appliance.
Never insert food into the Batchbowl by hand while the NutriBullet Baby is running.
Remove the Batchbowl from the Power Base to add ingredients.
CLEANING SAFEGUARDS
IMPORTANT SAFEGUARDS AND
CAUTIONARY INFORMATION
SAVE THESE INSTRUCTIONS
FOR YOUR SAFETY, CAREFULLY READ ALL INSTRUCTIONS
BEFORE OPERATING YOUR NutriBullet Baby.
When using electrical appliances, basic safety precautions should always be followed
including the following:
• Do not use appliance for other than intended use.
To avoid risk of electrical shock, never immerse the cord, plug or Power Base in
water or other liquids.
The use of attachments not recommended or sold by the manufacturer may cause
fire, electric shock or injury.
The use of attachments, including canning jars, not recommended by the
manufacturer may cause a risk of injury to persons.
Unplug the NutriBullet Baby when it is not in use, before putting on or taking off
parts, and before cleaning or assembling.
• Do not pull or twist the power cord.
• Do not allow the cord to dangle over the edge of a counter or table.
• Do not allow the cord to touch hot surfaces such as the stove.
Periodically inspect the cord and plug for damage. Do not operate any appliance
with a damaged cord or plug, if the appliance malfunctions, or is dropped or
damaged in any manner. If damaged, contact Customer Service for assistance in
obtaining a replacement.
Keep hands and utensils away from the blade while chopping or blending food to
reduce the risk of severe injury or damage to the unit. A scraper may be used to
move food around, but only when the unit is not running.
• Avoid contacting moving parts.
NEVER LET THE MOTOR RUN FOR MORE THAN ONE MINUTE AT A TIME AS IT
CAN CAUSE PERMANENT DAMAGE. IF THE MOTOR STOPS WORKING, UNPLUG
THE POWER BASE AND LET IT COOL FOR A FEW HOURS BEFORE ATTEMPTING
TO USE IT AGAIN. YOUR NUTRIBULLET BABY HAS AN INTERNAL THERMAL
BREAKER THAT SHUTS OFF THE UNIT IF IT OVERHEATS. THE POWER BASE
WILL RESET WHEN THE THERMAL BREAKER COOLS DOWN.
DO NOT USE ANY OF THE NUTRIBULLET BABY COMPONENTS (CUPS, LIDS,
BLADES, BATCH BOWL, BATCH TRAY, MOTOR) IN THE MICROWAVE.
• Always use your NutriBullet Baby on a clean, flat, hard, dry surface.
• Do not blend hot liquids in the short cup or any closed top container.
Never blend carbonated beverages. Released gases can cause pressure to build
up and the container to burst, resulting in possible injury.
DO NOT PUT THE NUTRIBULLET BABY BLADE HOLDERS AND OTHER PLAS-
TIC PARTS IN THE DISHWASHER. SIMPLY HAND WASH WITH WARM
SOAPY WATER.
DO NOT SUBMERGE THE POWER BASE IN WATER. WIPE OFF WITH A DAMP
CLOTH. ALWAYS UNPLUG BEFORE CLEANING.
THE NUTRIBULLET BABY BLADE HOLDERS AND OTHER PLASTIC PARTS
SHOULD NOT BE STERILIZED IN BOILING WATER OR STEAM FOR ANY
REASON AS THIS WILL WARP THE PLASTIC.
WHEN WASHING BLADES, DO NOT ATTEMPT TO REMOVE THE GASKET
RING. SIMPLY HAND WASH THE BLADES IN WARM SOAPY WATER.
DO NOT EXPOSE BLADE HOLDERS AND OTHER PLASTIC PARTS TO
EXTREME RAPID TEMPERATURES CHANGES, AS THIS MAY WARP OR
DAMAGE THE PLASTIC.
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for NutriBullet Baby Bullet at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of NutriBullet Baby Bullet in the language / languages: English as an attachment in your email.

The manual is 11,17 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of NutriBullet Baby Bullet

NutriBullet Baby Bullet Quick start guide - English, German, Dutch - 12 pages

NutriBullet Baby Bullet User Manual - Dutch - 61 pages

NutriBullet Baby Bullet Quick start guide - French, Italian - 12 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info