Manual Numark CDMix Bluetooth (page 5 of 36) (English, German, French, Italian, Spanish)

618155

Zoom out

Zoom in

1/36

REAR PANEL FEATURES

1. POWER CONNECTOR – Connect

the supplied power cable here.

2. POWER SWITCH – Turns the

machine on and off. The unit should

always be shut down with this

switch first before any external

power is removed.

3. LINE | PHONO INPUTS (RCA) –

Connect audio sources to these inputs. These inputs can accept both line and phono-level signals.

Note: Plug mono audio sources into both left and right inputs using a “Y” cable connector.

4. LINE | PHONO SWITCH – Flip this switch to the appropriate position, depending on the device connected to

the LINE | PHONO INPUTS. If using phono-level turntables, set this switch to "PHONO" to provide the

additional amplification needed for phono-level signals. If using a line-level device, such as a CD player or

sampler, set this switch to "LINE."

5. GROUNDING TERMINAL – If using phono-level turntables with a grounding wire, connect the grounding wire

to these terminals. If you experience a low "hum" or "buzz", this could mean that your turntables are not

grounded.

Note: Some turntables have a grounding wire built into the RCA connection and, therefore, nothing needs to be

connected to the grounding terminal.

6. AUX INPUT (RCA) – Connect an additional line-level audio source to this input. To route the AUX signal to the

mix, you will need to flip the AUX channel's INPUT SELECTOR (located on the top panel) to "AUX."

7. MIC 1 INPUT – Connect a microphone to this input with an XLR or

1/4" cable.

8. MIC 2 INPUT – Connect a 1/4” microphone to this input if you would

like to use an additional microphone on the Aux channel. To route

the MIC2 signal to the mix, flip the AUX channel's INPUT

SELECTOR (located on the top panel) to "MIC2."

9. MASTER OUTPUT (XLR) – Connect this low-impedance XLR output to a PA system or powered monitors.

Control the level of this output with the MASTER fader on the top panel.

10. MASTER OUTPUT (RCA) – Use standard RCA cables to connect this output to a speaker or amplifier system.

Control the level of this output by using the MASTER knob on the top panel.

11. ZONE OUTPUT (RCA) – Connect this output to an external monitoring device, such as a PA system, powered

monitors, or a home stereo. Control the level of this output with the ZONE knob on the top panel.

LCD FEATURES

1. PLAY / PAUSE – Illuminates when the unit is playing

or paused.

2. CUE – Flashes when a cue point is being set. This is

continuously lit when the unit is paused at a cue point.

3. FOLDER NUMBER – Shows the number of the

current folder.

4. TRACK NUMBER – Shows the current track number.

5. MINUTES – Shows the minutes elapsed or remaining

depending on the TIME MODE setting.

6. SECONDS – Shows the seconds elapsed or remaining depending on the TIME MODE setting.

7. FRAMES – The CD player breaks down a second into 75 frames for accurate cueing. This shows the frames

elapsed or remaining depending on the TIME MODE setting.

8. TIME BAR – Shows either time remaining or elapsed depending on the setting of the TIME button.

9. TIME MODE – Indicates whether the time shown on the LCD is the elapsed time for the track, remaining time

for the track, or total remaining time for the entire CD.

Note: When playing MP3 files, the total remaining time of the CD cannot be shown.

10. BPM – The tempo, which is indicated in BPM (beats per minute). When the automatic beat-counter is on, this

indicator will read "AUTOBPM."

11. PITCH – Shows the percentage change in pitch. When the lock icon is lit, the KEY LOCK button is engaged.

12. LOOP – Indicates when a loop is programmed. When the indicator is flashing, a loop is currently playing. When

"IN / OUT" is shown, a loop is programmed but not currently playing.

13. SINGLE – Shows when the unit is set to play just one track at a time (Single Play Mode). When this is not lit,

the CD will play continuously through all tracks (Continuous Play Mode). This function is controlled by the TIME

button.

Note: When in Single Play Mode, "AUTOCUE" will also be shown. When cueing up a new track, playback will

start when the actual audio of the track starts, eliminating the silence at the beginning of the track.

14. CD / MP3 – Shows when the unit is playing an audio CD or an MP3 CD.

15. MATRIX DISPLAY – Displays folder names and MP3 tag information. If reading a disc with no encoding, the

display will read “NO TEXT”. For CBR-recorded MP3 tracks, the bitrate will be shown. For VBR-recorded MP3

tracks, the display will only show "VBR".

Note: When connecting microphones,

make sure the mic channel's gain knob

is at the lowest setting.

910

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Numark CDMix Bluetooth in the language / languages: English, German, French, Italian, Spanish as an attachment in your email.

The manual is 4,68 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Numark CDMix Bluetooth Manual

Product: