586824
55
Zoom out
Zoom in
Previous page
1/89
Next page
53Original Instructions
12 Wireless communication - Wireless+/Deluxe
Intended use of radio equipment
WARNING!
Do not pull out the suction hose from the cleaner
while the motor/fan unit of the cleaner is running.
These machines have a safety shut o function.
This shut o function will be activated when the ma-
chine is operated with a closed vacuum socket.
12.1 Transceiver box
Before you mount the transceiver box to
the wall you should always test if you have
a signal between the transceiver box and
the hose handle in your entire home. Con-
nect the box to the cleaner and turn the
cleaner on and o using the hose handle
from di erent places in your home.
The rst transmission
The hose handle and the cleaner needs to have a rst
communication before starting the cleaner. This is also
valid if the hose handle has been replaced (spare part) or
if you want to connect an extra hose. Do like this before
starting your wireless cleaner:
1) Unplug the main cord.
2) Plug in the cord again, and then push the on/o button
at the hose handle for approximately 10 seconds. This
must be done within 60 seconds after the cleaner has
been plugged in
3) The handle and the cleaner do now communicate.
Installing the transceiver box
Mount the transceiver box on the wall minimum 1 meter
away from the cleaner for best signal between the trans-
ceiver box and the hose handle. The transceiver box can
be moved to di erent places in your home for a better
range by using an up to 30 meter network cable. Cables
can often be bought in your local Electronics store.
Connecting the transceiver box
To be able to use the wireless Nil sk hose handles, you
must rst connect the transceiver box to the cleaner. This
is done by using the 2 meter the network cable (RJ45)
that comes with the transceiver box. Connect the cable to
the transceiver box and the right socket in the back of the
cleaner.
12.2 Wireless hose handle
Instruction for use
The on-o function and power regulation is controlled by
radio technology. You do not have to point at the machine
like infra-red controls. The wireless bent end can be used
anywhere in the house.
Start and stop
Start: One push at the switch will start the cleaner.
Stop: One push at the switch will shut o the cleaner.
The power regulation can be adjusted in 5 steps. You
switch between the di erent steps by pressing the (+) or
(-) buttons at the hose handle.
Wireless
The LED-indicator is placed above the on/o button and
will be activated with di erent lights depending on the ac-
tions that are taken:
The lamp is activated at start or stop actions or when the
power regulation is adjusted.
The lamp ashes a warning light that indicates that the
bag lter/dust bag is clogged and needs cleaning/replace-
ment.
You must then check and clean or replace the lter/bag.
Deluxe info center display
The display is placed above the on/o button and will
show di erent symbols depending of the status of the
cleaner.
Speed level: Bars shows the actual speed level
Low Battery ashing: Battery is under 5%, Change bat-
tery.
Service warning / Air ow blocked lit: Indicates for both
Service warning and Blocked air ow. See 10 Trouble-
shooting
Check bag/ lter ashing: It is almost time to change
dust bag and clean lter.
Check bag/ lter lit: Dust bag or lter is clogged. Change
dust bag and clean lter.
Signal ashing: Hose handle is out of range. No connec-
tion to the cleaner.
Overheat ashing: Thermal cut-out has tripped and the
cleaner has stopped. See 10 Troubleshooting
Battery
The lifetime of the enclosed batteries in the bent end is ap-
proximately three (3) years. If the battery capacity at opera-
tion start is to low, the cleaner will then be shut o . If the
cleaner would not start or the power regulation via the hose
handle does not work, you must replace the batteries at the
hose handle. Replace to battery type 1.5V AAA. For more in-
formation and trouble shooting see chapter 10 in this instruc-
tion for use.
How to replace battery at the
hose handle
1) Open the lid of the battery
holder by sliding the lid towards
the front of the hose handle.
2) Replace the used batteries with
two new ones, type 1.5V AAA.
Make sure the polarity of the
batteries is placed correct at the
bracket.
3) Slide the battery lid back until
you hear a click.
On/O
Power
regulation +
Power
regulation -
LED-
indicator
Overheat
Signal
strength
Bag/ lter
Speed
Low battery
Service
55


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Nilfisk Supreme LCD at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Nilfisk Supreme LCD in the language / languages: Danish, Swedish, Finnish as an attachment in your email.

The manual is 3,76 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Nilfisk Supreme LCD

Nilfisk Supreme LCD User Manual - English - 26 pages

Nilfisk Supreme LCD User Manual - German - 27 pages

Nilfisk Supreme LCD User Manual - French - 25 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info