Manual Nilfisk-ALTO P 150.2 (page 4 of 22) (English)

454233

Zoom out

Zoom in

1/22

Nilfisk P 130.2 / P 150.2 / P 160.2

Original instructions

footwear on yourself or other

persons.

 Hold the spray lance ﬁ rmly

with both hands. The spray

lance is affected by a thrust

of up to 16.4 N during ope-

ration.

 The operator and anyone in

the immediate vicinity of the

site of cleaning should take

action to protect themselves

from being struck by debris

dislodged during operation.

Wear goggles during opera-

tion.

 This appliance has been de-

signed for use with cleaning

agents supplied or recom-

mended by the manufacturer.

The use of other cleaning

agents or chemicals may

adversely affect the safety of

the appliance.

 Disconnect from electrical

power supply before carrying

out user maintenance.

 To ensure the appliance

safety only use original spare

parts from the manufacturer

or approved by the manufac-

turer.

 High pressure hoses, ﬁ ttings

and couplings are important

for the safety of the appli-

ance. Only use hoses, ﬁ ttings

and couplings recommended

by the manufacturer.

 Do not use the appliance

if a supply cord or impor-

tant parts of appliance are

damaged, e.g. safety device ,

high pressure hose and trig-

ger gun.

 Remove the plug from the

socket outlet during cleaning

or maintenance and when

replacing parts or converting

the machine to another func-

tion.

 Appropriate ear protection

must be used.



Do not cover the machine

during operation.

 Never use the machine in

an environment where there

could be a danger of explo-

sion. If any doubt arises,

please contact the local

authorities.

 It is not allowed to clean

asbestos- containing surfaces

with high pressure.

 Do not spray ﬂ ammable liq-

uids.

 If the machine is left or not

used for 5 min., it must be

switched off on the start/stop

switch.

This high pressure washer

must not be used at tem-

peratures below 0°C.

Never let any persons stay

under the product when

stored on the wall.

WARNING!

Inadequate extension cables

can be dangerous. If an ex-

tension cable is used, it shall

be suitable for outdoor use,

and the connection has to be

kept dry and off the ground.

It is recommended that this

is accomplished by means of

a cable reel which keeps the

socket at least 60 mm above

the ground.Cables on extension

lead drums should always be

completely unwound to prevent

the cable from overheating.

Extension cables must comply

with the below-mentioned re-

quirements for length and cable

dimensions.

1.0 mm² max. 12.5 m

1.5 mm² max. 20 m

2.5 mm² max. 30 m

 If the electric cable is

damaged, it must be re-

placed by the manufacturer

or his service agent or simi-

larly qualiﬁ ed person in order

to avoid a hazard.

Mains power connection

The following should be ob-

served when connecting the

high pressure washer to the

electric installation:

 Only connect the machine to

an installation with earth con-

nection.

 The electric installation shall

be made by a certiﬁ ed elec-

trician and comply with IEC

364.

 It is recommended that the

electric supply to this ap-

pliance should include a

residual current device that

will interrupt the supply if the

leakage current to earth ex-

ceeds 30 mA for 30 ms.

Water connection

Connection to the public mains

according to regulations.

The machine is

not suitable for

connection to the

potable water

mains.

This high pressure washer

is only allowed to be con-

nected with the drinking water

mains, when an appropriate

backﬂ ow preventer has been

installed, Type BA according to

EN 60335-2-79. The backﬂ ow

preventer can be ordered un-

der number 106411177. The

length of the hose between

the backﬂ ow preventer and the

high pressure washer must be

at least 10 metres to absorb

possible pressure peaks (min

diameter ½ inch).

Operation by suction (for ex-

ample from a rainwater vessel)

is carried out without backﬂ ow

preventer. Recommended suc-

tion set: 126411387.

As soon as water has ﬂ own

through the BA valve, this water

is not considered to be drinking

water any more.

IMPORTANT! Only use wa-

ter without any impurities. If

there is a risk of silt, sand or

sediment in the inlet water (i.e.

from your own well), an addi-

tional ﬁ lter should be mounted.

Safety devices

Locking device on spray handle

(7a) (see illustration at the end

of this manual):

The spray handle features a

locking device. When the button

is activated, the spray handle

cannot be ope rated.

Machine just stopped! Been through all obvious faults i.e. fuse, mains cb, waited for thermal reset……… motor seems dead?
Looked for a reset button but appears not to be one? Submitted on 30-5-2022 at 18:59
Reply Report abuse

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Nilfisk-ALTO P 150.2 in the language / languages: English as an attachment in your email.

The manual is 1,4 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Nilfisk-ALTO P 150.2

Nilfisk-ALTO P 150.2 User Manual - German - 25 pages

Nilfisk-ALTO P 150.2 User Manual - Dutch - 21 pages

Nilfisk-ALTO P 150.2 User Manual - French - 25 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Nilfisk-ALTO P 150.2 Manual

Product: