609103
21
Zoom out
Zoom in
Previous page
1/25
Next page
21
NEPTUNE SB
1)
Options / model variants
Original instructions
Indication
on Display
Cause Remedy
FLF
FLF
> Flow sensor fault
Contact Nilfi sk-ALTO Service
Cold water operation possible
FLO
FLO
> Water supply turned off or inadequate supply
to machine
Required volume fl ow and pressure see
chapter 9.4 Technical Data
> Detergent tank empty Fill detergent tank or set detergent me-
tering to „OFF“
>
Pressure regulation on the safety control
block set to low water volume
Turn the twist grip on safety control block
to higher water pressure/volume
> Machine scaled Contact Nilfi sk-ALTO Service
Fue
Fue
>
Fuel shortage Fill fuel tank
Cold water operation possible
Hop
Hop
> Motor overheated Turn main switch in position „OFF“, let
machine cool down
Remove extension cord, if being used.
Possible phase failure; have electrical
connections checked
HOS
HOS
> Machine overheated Contact Nilfi sk-ALTO Service
LEA
LEA
> Leakage or inadmissible operating condition
by short-time operation
After three times of short-time ope ration
the machine switches off. To reset: Turn
main switch to position “OFF“, then start
again. Keep trigger squeezed for longer
than 3 seconds. If a leak occurs in the
hose and gun and causes the machine
to start and stop briefl y 3 times, then the
machine will switch off.
> Spray gun leaking Repair Spray gun
> High pressure hose, coupling or line system
leaking
Replace high-pressure hose, retighten
screw fi ttings
> Detergent tank empty Fill detergent tank or set detergent me-
tering to „OFF“
> Water inlet fi lter dirty Clean fi lter (see chapter 7.2.1)
> High-pressure pump drawing in air Repair leaks
LHE
LHE
> Flame sensor sooted Clean flame sensor (see chapter
7.2.6).
> Ignition or fuel system failure
Contact Nilfi sk-ALTO Service
Cold water operation possible
LHL
LHL
> Burner failure
Contact Nilfi sk-ALTO Service
Cold water operation possible
POL
POL
> Pump oil low
Fill to proper level (see chapter 7.2.3)
SEC
SEC
> Temperature sensor damaged
Contact Nilfi sk-ALTO Service
Cold water operation possible
SEO
SEO
> Temperature sensor damaged
Contact Nilfi sk-ALTO Service
Cold water operation possible
UPC
UPC
> Microprocessor failure Contact Nilfi sk-ALTO Service
8 Troubleshooting
8.1 Indications on Display
21


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Nilfisk-ALTO NEPTUNE SB at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Nilfisk-ALTO NEPTUNE SB in the language / languages: English as an attachment in your email.

The manual is 1,37 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Nilfisk-ALTO NEPTUNE SB

Nilfisk-ALTO NEPTUNE SB User Manual - German - 24 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info