641176

Niagara B264 Standalone Encoder Manual

1
Zoom out
Zoom in
Previous page
1/4
Next page
1
B264 Encoder and BRD Decoder Quick Start
The B264 Encoder and BRD Decoder stand-alone devices are managed through the Dashboard
application. Dashboard can control both the stand-alone devices, as well as openGear frames.
The user interface for the modular device is essentially the same as the corresponding openGear
cards. In this guide, we will refer to the B264 and BRD products as the “Device”.
The steps are as follows:
1. The first step is to install the Dashboard software. Dashboard is available for Windows,
Linux
1
, and Mac OSX. You can find the installers in the Dashboard Software directory
in the enclosed CD.
2. By default, the Device is configured with a factory IP address of 192.168.1.30 and a
subnet mask of 255.255.255.0. In order to perform the initial configuration, you will
need to configure the PC/Mac running Dashboard for an IP address in the same network.
We suggest you use 192.168.1.2. Once you gain access to the Device, you can
reconfigure its IP address to whatever value you require, or configure it to run DHCP.
3. Connect the PC/Mac running Dashboard and the Device to the same network. For
simplicity, even running an Ethernet cable between the two devices will work. The
Device has auto-crossover capabilities, so any Ethernet cable will work. Connect the
cable to a control ports in the Device, as illustrated below:
B264 Encoder with Unbalanced Audio Inputs
ETH1CTRL1
L AUD1 R ASI1 VID1
ETH2CTRL2
L AUD2 R ASI2 VID2
I
0
Control Ports
1
Dashboard is not officially supported in 64-bit Linux distributions. Please consult the README.TXT file in the
Linux directory for more details.
1


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Niagara B264 Standalone Encoder at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Niagara B264 Standalone Encoder in the language / languages: English as an attachment in your email.

The manual is 0,51 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Niagara B264 Standalone Encoder

Niagara B264 Standalone Encoder User Manual - English - 120 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info