727330
4
Zoom out
Zoom in
Previous page
1/28
Next page
4
a
Quick start guide
Smoke alarm DTCTSL50WT
For more information see
the extended manual online:
ned.is/dtctsl50wt
Intended use
This product is intended for smoke detection. Other
uses or changes to the product constitute improper
use and carry serious risk of accidents. This product
is for indoor use only. This product is not intended
for commercial use.
The product must not be mounted in damp rooms,
near doors, windows, ventilators or radiators.
Any modication of the product may have
consequences for safety, warranty and proper
functioning.
Main parts (image A)
Smoke alarm
Indicator LED
“Test / Hush button
Magnet
Mounting bracket
Screw (3 x 25 mm)
Plug (6 x 28 mm)
Preparation (image B - D)
Install the product on the wall or ceiling.
The product must be installed:
In each room.
On each oor.
In the hallway.
In the staircase.
In the storage room.
In spaces with electric equipment.
-
Do not install in the tip of a sloping ceiling as
smoke-free air can collect in these areas.
Install the product on the ceiling where 1 m from
the highest point of the ceiling.
Install the product at least 61 cm from the corner
of the wall.
Install the product at least 50 cm from
uorescent light sources.
Installation of the product (image E)
1. Turn A
5
counterclockwise to remove it from
A
1
.
2. Remove A
4
from A
1
to switch on the
product.
3. Place A
5
in the desired location.
4. Use A
5
to mark the drill locations with a pencil.
5. Drill two Ø 6 mm holes.
6. Insert the plugs.
7. Fasten the mounting bracket with A
6
.
8. Turn A
1
clockwise to attach it to A
5
.
Testing the product
The product must be tested to ensure proper
operation.
1. Press and hold A
3
until the product emits a
continuous “beep” and A
2
starts blinking.
2. Release A
3
. The “beep” stops and A
2
stops
blinking.
The product is now in hush mode.
3. Repeat the above steps to exit the hush mode
and nish the test.
Hush mode
In hush mode, the product does not detect smoke
for 9 minutes.
The hush mode must be activated manually.
1. Press A
3
shortly to activate hush mode. The
LED blinks every 10 seconds.
After 9 minutes, the product goes back into standby
mode.
Tip: To leave the hush mode early, hold down A
3
until the product emits a “beep”.
4
Note: In hush mode, the alarm is still triggered
when the smoke concentration in the ambience
is over 4 times the minimum alarming value.
Status of smoke alarm
LED light Sound alarm
Standby mode Blinks every
344 s
O
Hush mode Blinks every
10 s
O
Test Blinks
continuously
Continuous
“beep”
Low-battery
condition
No LED
function
A “beep” every
43 s
Malfunction
or end-of-life
No LED
function
A series of
“beeps” every
43 s
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Nedis DTCTSL50WT at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Nedis DTCTSL50WT in the language / languages: All languages as an attachment in your email.

The manual is 1,07 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Nedis DTCTSL50WT

Nedis DTCTSL50WT User Manual - English - 1 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info