745043
5
Zoom out
Zoom in
Previous page
1/12
Next page
INTRODUCTION
GETTING STARTED
WHAT’S IN THE BOX
Packed with your M27 you will nd
A detachable mains power cord
Four pieces of magnetic feet
USB ash drive
Cleaning cloth
Quick Setup Guide
NOTE
Connect supplied USB ash drive to any compatible device to view the
M27 owner’s manual and Quick Setup Guide.
QUICK SETUP GUIDE
In case you simply cannot wait to experience the performance of your
new NAD M27 Seven Channel Power Amplier, the following QUICK SETUP
GUIDE is recommended to help you get started.
Ensure that the M27 is unplugged before making any connections. It is
also advisable to power-down or unplug all associated components while
making or breaking any signal or AC power connections.
1 Set the external source's volume control to minimum level. External
source can be a preamplier, processor, amplier or any applicable
device.
2 Set SELECT switch to BALANCED or SINGLE-ENDED. Connect the analog
audio output of your external source to the M27 rear panel’s BALANCED
or SINGLE-ENDED analog audio input. Depending upon the source’s
conguration, analog audio input connection can be made up to seven
channels either via BALANCED or SINGLE-ENDED input ports.
3 Connect your speakers to the SPEAKER terminals of M27. Note
suggested speaker connections as reected in the rear panel channel
allocations.
4 Plug-in to a mains power source the M27’s supplied mains power cord.
Connect corresponding end of the mains power cord to the AC mains
input of M27 and the plug connected to a mains power source.
5 Plug-in also to a mains power source the external source’s mains power
cord. Power up the external source ahead of the M27.
6 Set to ON the rear panel POWER switch of M27. The M27 goes to
standby mode as shown by the amber status condition of the Power
indicator.
7 Press (Standby) button for the M27 to be switched ON from standby
mode. The Power indicator will turn from amber to bright/white color.
The M27 is ready for operation.
8 Adjust the external sources volume control according to desired
listening level.
SAVE THE PACKAGING
Please save the box and all of the packaging in which your M27 arrived.
Should you move or otherwise need to transport your M27, this is by far the
safest container in which to do so. We’ve seen too many otherwise perfect
components damaged in transit for lack of a proper shipping carton, so
please: Save that box!
NOTES ON INSTALLATION
Your NAD M27 should be placed on a rm, level surface.
Avoid placing the unit in direct sunlight or near sources of heat and
damp.
Allow adequate ventilation.
Do not place the unit on a soft surface like a carpet.
Avoid placing the M27 inside a closed cabinet that is not well ventilated
as this may compromise the M27’s performance and reliability.
Ensure that the M27 is unplugged before making any connections.
For best performance, use quality speaker leads of 16 gauge (1.5mm
2
)
thickness or more.
If the unit is not going to be used for some time, disconnect the plug
from the mains power source.
Use a dry cloth for cleaning.
DO NOT REMOVE THE COVER; THERE ARE NO USERSERVICEABLE
PARTS INSIDE.
BARE WIRES AND PIN CONNECTORS
WARNING: The terminals marked with this symbol
are hazardous live. External wiring connected to these
terminals requires installation by an instructed person or
the use of ready-made leads or cords.
Bare wires and pin sockets should be inserted into the hole in the shaft
of the terminal. Unscrew the speaker terminal’s plastic bushing until the
hole in the screw shaft is revealed. Insert the pin or bare cable end into
the hole and secure the cable by tightening down the terminal’s bushing.
Ensure bare wire from the speaker cables does not touch the back panel or
another socket. Ensure that there is only 1/2” (1cm) of bare cable or pin and
no loose strands of speakers wire.
FEET INSTALLATION
The supplied magnetic feet can be easily installed by aligning and attaching
them to their corresponding foot shoe. Refer to illustration below.
^
5
ENGLISHFRANÇAISESPAÑOLITALIANODEUTSCHNEDERLANDSSVENSKAРУССКИЙ
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for NAD M27 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of NAD M27 in the language / languages: English as an attachment in your email.

The manual is 2 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of NAD M27

NAD M27 Quick start guide - English - 2 pages

NAD M27 User Manual - German - 12 pages

NAD M27 User Manual - Dutch - 12 pages

NAD M27 User Manual - French - 12 pages

NAD M27 User Manual - Italian - 12 pages

NAD M27 User Manual - Swedish - 12 pages

NAD M27 User Manual - Spanish - 12 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info