745039
5
Zoom out
Zoom in
Previous page
1/14
Next page
ENGLISH
5
INTRODUCTION
GETTING STARTED
WHAT’S IN THE BOX
Packed with your M22 you will nd
A detachable mains power cord
Four pieces of magnetic feet
USB ash drive
Cleaning cloth
Quick Setup Guide
QUICK SETUP GUIDE
In case you simply cannot wait to experience the performance of your new
M22, the following QUICK SETUP GUIDE is recommended to help you get
started.
Ensure that the M22 is unplugged before making any connections. It is
also advisable to power-down or unplug all associated components while
making or breaking any signal or AC power connections. Set the external
source's volume control to minimum level. External source can be a
preamplier, processor, amplier or any applicable device.
1 Set SELECT switch to BALANCED or SINGLE-ENDED. It is important that
the selection for ANALOG AUDIO INPUT must be the same for both L
(left) and R (right) channels.
2 Connect the analog audio output of your external source to the M22
rear panel’s BALANCED or SINGLE-ENDED analog audio input.
3 Connect your speakers to the LEFT and RIGHT SPEAKERS terminals of
M22.
4 Ensure that the supplied power cord’s female connector end is rmly
secured to M22’s AC Mains input socket and the male plug connected
to the mains power source.
5 Power up the external source ahead of the M22.
6 Set to ON the rear panel POWER switch of M22. The M22 goes to
standby mode as shown by the amber status condition of the Power
indicator.
7 Press o (Standby) button for the M22 to be powered up from standby
mode. The Power indicator will turn from amber to bright/white color.
The M22 is ready for operation.
8 Adjust the external sources volume control according to desired
listening level.
SAVE THE PACKAGING
Please save the box and all of the packaging in which your M22 arrived.
Should you move or otherwise need to transport your M22, this is by far the
safest container in which to do so. We’ve seen too many otherwise perfect
components damaged in transit for lack of a proper shipping carton, so
please: Save that box!
NOTES ON INSTALLATION
Your unit should be placed on a rm, level surface.
Avoid placing the unit inside a closed cabinet that is not well ventilated
as this may compromise the M22’s performance and reliability.
Avoid placing the unit in direct sunlight or near sources of heat and
damp.
Allow adequate ventilation.
Do not place the unit on a soft surface like a carpet.
For best performance, use quality speaker leads of 16 gauge (1.5mm
2
)
thickness or more.
If the unit is not going to be used for some time, disconnect the plug
from the mains power source.
Use a dry cloth for cleaning.
DO NOT REMOVE THE COVER; THERE ARE NO USERSERVICEABLE
PARTS INSIDE.
BARE WIRES AND PIN CONNECTORS
WARNING: The terminals marked with this symbol
are hazardous live. External wiring connected to these
terminals requires installation by an instructed person or
the use of ready-made leads or cords.
Bare wires and pin sockets should be inserted into the hole in the shaft of
the terminal. Unscrew the speaker terminal’s bushing until the hole in the
screw shaft is revealed. Insert the pin or bare cable end into the hole and
secure the cable by tightening down the terminals bushing. Ensure bare
wire from the speaker cables does not touch the back panel or another
socket. Ensure that there is only 1/2” (1cm) of bare cable or pin and no loose
strands of speakers wire.
FEET INSTALLATION
The supplied magnetic feet can be easily installed by aligning and attaching
them to their corresponding foot shoe. Refer to the illustration below.
^
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for NAD M22 V2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of NAD M22 V2 in the language / languages: English as an attachment in your email.

The manual is 1,7 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of NAD M22 V2

NAD M22 V2 User Manual - German - 13 pages

NAD M22 V2 User Manual - Dutch - 12 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info