562258
5
Zoom out
Zoom in
Previous page
1/16
Next page
IDENTIFICATION OF CONTROLS
1 o (STANDBY)
With the corresponding end of the mains power cord connected
to the AC mains input of the D7050 and the plug connected to a
mains power source, press o (Standby) to switch ON the D7050
from standby mode. The Standby indicator will turn from amber to
bright/white color. Pressing o (Standby) again turns the unit back
to standby mode.
IMPORTANT NOTES ABOUT STANDBY MODE
The following conditions describe Standby Mode response with respect
to AUTO SHUTOFF as congured in the D 7050 app. Refer to section below
about "NAD D 7050 APP" for further information.
Condition 1
AUTO SHUTOFF in the D 7050 app is set to “ON”
D 7050 will automatically go to standby mode if there are no user
interface interaction and no active source within 30 minutes.
Condition 2
AUTO SHUTOFF in the D 7050 app is set to “OFF” or no D 7050 app is used
to control the D 7050
D 7050 will not go to standby mode at any time unless directly initiated
by pressing o (Standby) switch or OFF from the remote control.
The default setting of AUTO SHUTOFF is OFF.
2 VOLUME
Adjust audio level by turning clockwise or counterclockwise.
3 INPUT
Rotate to select desired input source.
4 DISPLAY
Illuminate the selected or active source (COAXIAL1, COAXIAL2,
OPTICAL1, OPTICAL2, COMPUTER, AIRPLAY, DOCK, BT) and current
audio level.
Display follows the orientation of the unit - vertical or horizontal
view as shown on the front cover.
IMPORTANT NOTE
Display shall temporarily turn o if there is no user interface interaction
within 5 minutes. Restore display by sending a remote control
command or rotating any of the controls.
5 PHONES
A 3.5 mm stereo jack socket is supplied for headphone listening.
Specially designed low noise headphone circuitry can accommodate a
wide range of phones, even 600 Ohm studio models.
Adjust headphone audio level by rotating the VOLUME control
clockwise or counterclockwise.
Ensure that the volume control is turned to minimum (fully
counterclockwise) before connecting or disconnecting
headphones. Listening at high levels can damage your hearing.
Inserting a headphone jack into this socket automatically switches
o the loudspeakers.
6 RESET
Restore factory default settings.
7 WPS/JB
Use to setup wireless network connection.
8 AUDIO OUT
These output terminals have dual function. They are used either as
PRE OUT or SUBWOOFER terminals.
Always turn OFF the D 7050 and associated external devices before
connecting or disconnecting anything to the AUDIO OUT sockets.
PRE OUT
The AUDIO OUT sockets can be used to drive an additional amplier.
Use a dual RCA cable to connect AUDIO OUT to the corresponding
analog audio input of compatible devices such as ampliers,
receivers or other applicable devices.
AUDIO OUT will be aected by the D 7050’s volume control settings.
Rotate the VOLUME control to adjust the output level of the AUDIO
OUT sockets.
SUBWOOFER
Use a dual RCA cable to connect AUDIO OUT to the low level input
of a powered subwoofer.
Low frequency information up to 200Hz is sent to the connected
subwoofer via AUDIO OUT.
AUDIO OUT
+12V
TRIGGER
IN
OPTICAL
COMPUTER
DIGITAL AUDIO INPUT
LAN
100-240V 50/60Hz
SPEAKERS
RI G HT
LE F T
WPS/JBRESET
21
1
2
L
R
COAXIAL
6 7 8 9
10 11 12 13 14 15
2
1
3
4
5
5
ENGLISHPORTUGUÊS FRANÇAISESPAÑOLITALIANODEUTSCHNEDERLANDSSVENSKAРУССКИЙ
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for NAD D7050 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of NAD D7050 in the language / languages: English as an attachment in your email.

The manual is 4,03 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of NAD D7050

NAD D7050 Installation Guide - English - 2 pages

NAD D7050 User Manual - German - 16 pages

NAD D7050 User Manual - Dutch - 20 pages

NAD D7050 User Manual - French - 16 pages

NAD D7050 User Manual - Swedish - 16 pages

NAD D7050 User Manual - Spanish - 20 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info