1. Remove the battery compartment door by applying thumb pressure to
area indicated on battery door and then lift the door out and off the cabinet.
2. Insert 4 x 1.5 V “D” / R20 / UM1 batteries with the + and - marks correctly
aligned (not included) into the compartment.
3. Replace the compartment door.
Notes on batteries
• Do not mix different types of batteries or old batteries with new ones.
• Never recharge the batteries, apply heat to them or take them apart.
• Battery shall not be exposed to excessive heat such as sunshine,fire or
the like.
• Attention should be drawn to the environmental aspects of battery disposal.
• The batteries need to be replaced when:
The volume decreases, or sound is distorted during operation.
NOTE:In order to avoid leakage, always remove the batteries when unit will
not be used for a long period of time.
POWER ON / OFF THE UNIT
1. Press the ON/OFF to turn on the radio. The display will change to show
radio frequency.
2. Press the ON/OFF to turn off the radio. The display will revert to current
time.
SET CLOCK
After the batteries are installed, the display will show “00:00”
1. Press MEMO/SET once and you will see the flashing display.
2. Press MIN. or HOUR to set the time.
3. Press MEMO/SET again when finished.
RADIO
Using the radio
1. Press the ON / OFF to turn on the radio.
2. Press BAND to select AM or FM bands.
3. Press MIN. / HOUR or to tune to your desired radio station.
4. Adjust the volume by (10).
To enhance radio reception ability:
FM: Extend and rotate the antenna
AM: Rotate and move the unit horizontally for optimum reception.
SETTING THE ALARM
1. Press ALARM that you will see a flash ‘ ALARM’ on the display.
2. Press MIN. / HOUR to adjust your desired alarm time. The
display will revert to current time after 5 seconds from your adjustment.
TO CANCEL THE ALARM SETTING
1. Press MEMO / SET that the display will flash.
2. Press ALARM twice and the ‘ALARM’ indicator disappear, the alarm
stop.
SLEEP TO MUSIC
1. Press SLEEP to select among off 90.80.70……10 minutes. Then change
to the radio automatically and you will see the ‘SLEEP’ on the display.
Connect the earphones ( not included) to the earphone jack on unit.
LISTENING WITH EARPHONES
In full power, the continuous listening of the player may damage
the user’s hearing.
CONNECTING THE AUX
Connect your auxiliary source ( e.g.mp3 player) to the AUX input jack on
the right side of the unit, the unit will change to AUX function automatically.
CONNECTING POWER CORD
1. Connect the detachable AC cord (included) to the AC socket on the rear
of the unit.
2. Plug the power cord into 230V-50Hz AC outlet.
MORE INFORMATION
CAUTION: To reduce the risk of electric shock, do
not remove the cover (or back). There are no user
serviceable parts inside the unit. Refer all servic-
ing to qualify personnel.
The exclamation point within the triangle is a warning sign alerting
the user of important instructions accompanying the product.
The lightening flash with arrowhead symbol within the triangle is a
warning sign alerting the user of “ dangerous voltage” inside the
unit.
IMPORTANT!
The ventilation should not be impeded by covering the ventilation open-
ings with items such as newspapers, table-cloths, curtains, etc.
No naked flame sources, such as lighted candles, should be placed on
the apparatus.
The use of apparatus in moderate climates.
The apparatus should not be exposed to dripping or splashing.
Ensure a minimum distance of 5cm around the apparatus for sufficient
ventilation.
Do not place objects filled with liquids, such as vases, on the apparatus.
Excessive sound pressure from earphones and headphones can cause
hearing loss.
The marking plate is located on the botton of unit.
Mains plug is used as the disconnect device and it shall remain readily
operable. To be completely disconnected the power input, the mains plug
of the apparatus shall be disconnected from the mains completely. The
mains plug should not be obstructed or should be easily accessed during
intended use.
Under the influence of electrical fast transient or/and electrostatic
phenomenon, the product may malfunction and require user to power
reset.
-
-
-
-
-
-
-
-
-
-
If at any time in the future you should need to dispose of this
product please note that Waste electrical products should not be
disposed of with household waste. Please recycle where facili-
ties exist. Check with your Local Authority or retailer for recycling
advice.(Waste Electrical and Electronic Equipment Directive)
1 - GB
3 - GB4 - GB
Saving Preset Stations
1. Tune to a station to be saved as a preset station ( see “Using the Radio”).
2. Press MEMO / SET once and you will see a flashing ‘MEMORY’ on the
display.
3. Press MEMO button / to select a preset number.
4. Press MEMO / SET to save station as selected preset number.
5. Repeat above steps to preset a maximum of 10 stations for AM and FM
respectively.
Selecting Preset Stations
1. Make sure you are in preset mode.
2. Press MEMO button / to select a preset number.
Stopping the alarm
When the alarm is triggered, press ALARM button to stop it.
Note:
- The AC cord must be unplugged from both the jack on the unit and the
power outlet for the unit to run on the batteries.
- When the AC cord is connected from the main unit to the power outlet, the
power source automatically switches to AC. You may leave the batteries
inside the unit if you wish. There is no battery consumption when the AC
cord is connected to a power outlet and/or the the unit.
2 - GB
5 - GB
Need help? Post your question in this forum.
Report abuse
Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.
Product:
Forumrules
To achieve meaningful questions, we apply the following rules:
First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.
Register
Register getting emails for Muse M-087 at:
new questions and answers
new manuals
You will receive an email to register for one or both of the options.
Get your user manual by e-mail
Enter your email address to receive the manual of Muse M-087 in the language / languages: English as an attachment in your email.
The manual is 1,03 mb in size.
You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.
If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.
The email address you have provided is not correct.
Please check the email address and correct it.
Your question is posted on this page
Would you like to receive an email when new answers and questions are posted? Please enter your email address.
