507839
23
Zoom out
Zoom in
Previous page
1/25
Next page
English User manual
20
Exchanging the headlight
bulbs
Open the engine bonnet.
On the bulb unit (a), remove the
cable (b).
Turn the bulb unit to the left by a
quarter of a revolution and
remove from the reflector (c).
Exchange the bulb with a bulb of
the same wattage.
Replace the bulb unit into the
reflector and secure it (by turning
a quarter of a revolution to the
right).
Mount the cable on the bulb unit.
Close the engine bonnet. Check
that it is fully engaged.
Exchanging the tail light bulbs
Turn the bulb mounting anti-
clockwise until the tounges on the
mounting oppose the notches in
the tail light reflector.
After bringing into line, carefully
pull the mounting out of the tail
light reflector.
Remove the bulb from the
mounting and replace it with
a new one.
Bring the tounges on the
mounting into line with the
notches in the reflector and
carefully push the mounting into
place. Tightly turn the mounting in
a clockwise direction.
Exchanging the indicator
bulbs
Loosen the screws on the lens
and remove the lens.
In order to remove the bulb from
the lamp mounting, press the
bulb in a little and turn it anti-
clockwise.
Align the new bulb on the
mounting slot, press the bulb into
the mounting and screw it into the
mounting in a clockwise direction.
Secure the lens again using the
screws.
Exchanging the fuses
The tractor’s electric system is
protected from high current damage
with fuses. Always replace fuses
with those of the same amperage.
If the electric system does not work,
check for fuses which have been
tripped.
If the electrical system regularly trips,
take it to a specialist workshop.
Fuses in the cable trunk
The fuses in the tractor cable (3)
trunk protect the entire electrical
system of the tractor.
A defective fuse is exchanged as
follows:
Open the bonnet and remove the
right side covering
In front of the cross-sheet,
localise the fuse holder (1) directly
on the right hand side, on the
inner side of the instrument
holder.
Remove the fuse (2) from the
holder and replace it with one of
the same amperage. NEVER
replace it with one of a higher
amperage.
Attach the side covering and
reclose the bonnet.
Tyre pressure
t~êåáåÖ
kÉîÉê=ÉñÅÉÉÇ=íÜÉ=ã~ñáãìã=
éÉêãáííÉÇ=íóêÉ=éêÉëëìêÉ=EëÉÉ=ëáÇÉ=çÑ=
íóêÉFK=tÜÉå=éìãéáåÖ=ìé=íÜÉ=íóêÉëI=
Çç=åçí=ëíÇ=áå=Ñêçåí=çê=~ÄçîÉ=íÜÉãK
The recommended tyre operating
pressure is:
For tyre equipment suitable for
lawns:
Over-inflating reduces the longevity
of the tyres. Tyre pressure should be
checked before every journey.
Notes concerning wheel
change
t~êåáåÖ
låäó=ìëÉ=~ééêçîÉÇ=îÉÜáÅäÉ=à~ÅâëK=
Work safely. Only tighten the screws
/ nuts crosswise using a torque key.
The starting torque for the screws /
nuts:
Front wheels 74 Nm
Rear wheels 108 Nm
a
b
c
1
2
3
Dimension
Tyre
pressure
front 23 x 9.5 – 12 0,7 bar
(0,8 max.)
rear 31 x 12 – 15 1.0 bar
(1.3 max.)
23


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for MTD CubCadet serie 6000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of MTD CubCadet serie 6000 in the language / languages: English as an attachment in your email.

The manual is 2,25 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of MTD CubCadet serie 6000

MTD CubCadet serie 6000 User Manual - German - 26 pages

MTD CubCadet serie 6000 User Manual - Dutch - 26 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info