Manual Monacor HDCAM-1010 (page 3 of 8) (English, German, French, Italian)

632490

Zoom out

Zoom in

1/8

HD-SDI Miniature Cameras

Please read these operating instructions carefully prior to

installation and keep them for later use.

1 Applications

These high-resolution colour cameras are especially

designed for use in video surveillance systems (CCTV).

They are equipped with a 4.3 mm fixed-focus lens. Cam-

era features include automatic day/ night switching, back-

light compensation, digital noise reduction, mirror-

inverted image display, zoom, motion detection and a

masking function to cover zones that are not to be moni-

tored. The cameras are equipped with a digital output

(SDI) for high-resolution image signals (HD) and with an

analog output for testing purposes.

2 Safety Notes

The camera corresponds to all relevant directives of the

EU and is therefore marked with

.

The camera is suitable for indoor use only. For outdoor

mounting, the camera must be placed into a weather-

proof protection housing.

Protect the camera against dust, humidity and heat

(admissible ambient temperature range:

10 °C to

+50 °C).

For cleaning only use a dry, soft cloth; never use water

or chemicals.

No guarantee claims for the camera and no liability for

any resulting personal damage or material damage will

be accepted if the camera is used for other purposes

than originally intended, if it is not correctly installed or

if it is not repaired in an expert way.

3 Installation

1) To find the optimum place of mounting, make a test

run.

2) Use the camera support to fasten the camera to the

ceiling or the wall, for example.

3) Use a 75 Ω cable to connect the BNC jack (4) to the

SDI video input of a monitor. The maximum cable

length possible depends on the cable quality. With

the low-loss special cable KHD-1 from MONACOR,

the maximum cable length is 170 m. Repeaters (e. g.

HDEXT-206) can be inserted to support cable lengths

of several hundred meters.

4) For testing purposes, an additional analog low-resolu-

tion video signal is available at the BNC inline jack (5).

5) Connect a regulated 12 V power supply with a perma-

nent rating of 120 mA to the red inline jack (3). A low-

voltage plug 5.5 / 2.1 mm (exterior / interior diameter) is

required. Make absolutely sure to observe the correct

polarity (centre contact =+).

6) Switch on the monitor connected and align the camera

by means of the monitor image: Loosen the setscrew(s)

(2) at the camera support, and position the camera as

desired. Then tighten the screw(s) again.

4 Adjustments via the On-screen Menu

The on-screen menu is operated by means of the control

lever (1). To display the on-screen menu, press the con-

trol lever. The main menu appears:

To select a menu item, tilt the lever vertically ; to change

the value or to select an option, tilt the lever horizontally

. When the symbol

↵

appears behind a menu item or

option, the lever can be pressed to call up a submenu or

to activate a function.

Please refer to the reverse page of these instructions for

a tabulated list of all available setting options.

EXPOSURE

WHITE BAL

DAY&NIGHT

BACKLIGHT

3D-DNR

IMAGE

MONITOR

SYSTEM

EXIT

If the camera is to be put out of operation defin-

itively, take it to a local recycling plant for a dis-

posal which is not harmful to the environment.

HDCAM-1010

HDCAM-1020

MONACOR INTERNATIONAL GmbH & Co. KG • Zum Falsch 36 • 28307 Bremen • Germany Copyright

Order No. 18.3530

Order No. 18.3540

To exit the menu, select the line

EXIT and press the lever.

If the lever is tilted to the left or the right while the menu is

not displayed, special menus will appear; the options of

these special menus are only designed for making the

basic factory settings during camera manufacturing

and should not be changed. Select the line

EXIT (= last

menu line) to exit these special menus.

5 Specifications

Image sensor: . . . . . . . . . CMOS chip, 8.5 mm (

⁄3″)

2 megapixels, progressive

scan

Number of pixels: . . . . . . . 1920 × 1080 max.

Lens: . . . . . . . . . . . . . . . . 4.3 mm/ 1 : 2.0

Minimum illumination: . . . 1 lx (colour)

0.5 lx (B/W)

SDI video formats: . . . . . . 1080p30, 1080p25,

720p60, 720p50

Analog video output: . . . . PAL / NTSC, 1Vpp / 75 Ω

S / N ratio: . . . . . . . . . . . . . > 50 dB (AGC off)

Power supply: . . . . . . . . . 12 V

, 120 mA

Admissible temperature: .

10 to +50 °C

Dimensions, weight

HDCAM-1010: . . . . . . . 30 × 30 × 20 mm, 100 g

HDCAM-1020: . . . . . . . ∅ 25 mm × 47 mm, 100 g

Subject to technical modification.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Monacor HDCAM-1010 in the language / languages: English, German, French, Italian as an attachment in your email.

The manual is 0,37 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Monacor HDCAM-1010 Manual

Product: