738810

Mesko MS 2920 Manual

4
Zoom out
Zoom in
Previous page
1/64
Next page
2. Open the shaver heads (fig. 17). Turn the lock counterclockwise to remove old blades and covers.
1. Switch the shaver off, unplug the power cable and unplug the small plug off the shaver.
Replace the shaving heads every year to ensure optimal device operation. The shaver has long durability if used according to the
manual. Damaged or worn shaving heads should be replaced only with original shaving heads.
Blade replacement
3. Every 6 months oil the trimmer teeth with machine oil (fig. 16).
2. Clean the trimmer using the attached brush (fig. 15).
1. Switch the shaver off, unplug the power cable and unplug the small plug off the shaver.
Clean the trimmer after each use.
Trimmer cleaning
4. Close the head until it snaps.
3. After cleaning put the blades into the cover and place the set in the casing, watching the guiding cuts on the cover edge (fig. 14).
Make sure the cut on the cover edge matches the tooth on the head casing. Next, put the securing element back on and turn the lock
clockwise.
The heads can be water rinsed.
2. Clean the blades and covers using the attached brush (fig. 13). Clean only one set of blade and cover per time. Do not mix the
blades and covers. The effective operation of each set can be assured only by exact fit of blades to covers.
1. Open the shaving assembly, turn the lock conterclockwise (fig. 12), remove the securing element, and remove the blades.
18. Do not touch the device or power adaptor with wet hands.
17. If the device falls into water, immediately remove the power plug or power adaptor from
the socket. If the device is powered, do not put hands in the water. Have the device
checked by the qualified electrician before using it again.
19. Never use this device close to water, e.g.: under shower, in bathtube, or above
sink filled with water.
20. If the device utilises a power adaptor, do not cover it, because this can cause a
dangerous temperature rise and can damage the device. Always connect the power
adaptor cable to the device, and then connect the power adaptor to the power socket.
21. The shaver charging temperature should not be above 35 degrees Celsius or below 5
degrees Celsius.
23. Do not use towel or paper tissues for cleaning of shaver head, as they can damage the
head.
22. Only the shaver head can be washed in water, the other parts of the shaver cannot be
immersed in water. Be careful, the hot water can cause burns to your hands.
SHAVER CHARGING
1. Switch the shaver on using the button on the housing.
2. Move the shaver head along the skin, making straight as well as circular moves (fig. 5).
3. After each use put the protective cover on for protection of the shaving heads against the mechanical damage (fig. 6).
USING SHAVER, SHAVING
4. If the battery is discharged during shaving, you can charge the shaver for a couple of minutes in order to finish shaving.
3. After full charging of the shaver, unplug the charger from the power socket, then disconnect the cable from the shaver.
Before charging make sure, that the shaver is switched off. Charging takes about 8 hours. The shaver cannot be plugged to the power
socket for longer than 24 hours.
1. Connect the charger cable to the shaver (fig. 3).
Clean the head and hair container daily.
1. Move the slide upwards to open the trimmer. You can use trimmer after switching the device on (fig. 7).
Cleaning shaver heads (every 6 months)
Frequent shaver cleaning ensures better shaving results.
For sideburns and moustache shaping.
2. Push the release button (fig. 8, 1), the shaving assembly will open (fig. 8, 2).
3. Every few shaves sweep out the cut hair out of the heads and container with attached brush.
CLEANING AND MAINTENANCE
2. The charging LED will illuminate (fig. 4).
1. Switch the shaver off, unplug the power cable.
16. Do not allow the device or power adaptor to wet.
USING TRIMMER, TRIMMING
4
… 4 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Mesko MS 2920 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Mesko MS 2920 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Spanish, Finnish as an attachment in your email.

The manual is 3,17 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info