494849
8
Zoom out
Zoom in
Previous page
1/10
Next page
8
The C50 contains ten identical channels of
audio amplification. Unless otherwise stated,
this section refers to one channel only.
Input connections
Two inputs are provided for each channel:
balanced(XLR-3F)andunbalanced(gold-
plated phono). Both inputs are simultaneously
active. As a result it is not recommended to
connect sources to both inputs on a channel
simultaneously as the output level and
behaviour will be unpredictable. In general,
the balanced inputs will be found to offer
approximately6dBgaincomparedtothe
unbalanced inputs.
The audio connections should be made with
highqualityaudiophonoleadsorXLRleads.
Trigger input
The unit is designed to be switched in and
out of standby by means of the application of
a trigger voltage via this 3.5 mm mono jack
socket. The application of an AC or DC voltage
between 5 and 30 volts will turn the unit on
(ie bring it out of standby). Removing the
voltage will return the unit to standby. Ensure
that the trigger source is configured to provide
a voltage within this range when the unit is
required to be switched on.
Output connections
Connect the cables from the rear-panel output
terminals to the loudspeakers. Be sure to
observe correct polarity and the source and
destination of each channel.
Note that these terminals can develop
significant voltages/current-passing capability
when the C50 is powered up and being
fed with an active signal. Ensure that
connections are made with the power
disconnected from the unit.
Temperature-controlled fan output
This 3.5mm jack provides a voltage and power
suitable for driving a fan system. The voltage
provided is 12vdc, tip positive. Up to 5W
can be taken from this socket. The voltage is
present only when the temperature of the unit
exceeds55degreesCelsiusmeasuredatthe
case of the unit.
OPERATING THE C50
Removal of the smoked acrylic front panel
allows access to the Standby button. Replace
the panel after use to avoid unintentional
operation.
The unit is normally operated via trigger input.
A front panel standby button is provided to
toggle the unit in and out of standby. It is not
intended that this button should be used for
normal operation.
OFF ON
CHANNEL 6 CHANNEL 5 CHANNEL 4 CHANNEL 3 CHANNEL 2 CHANNEL 1
FAN
OUT
CHANNEL 10 CHANNEL 9 CHANNEL 8 CHANNEL 7
Channel 1
Stand By Hot
Channel 2 Channel 3 Channel 4 Channel 5 Channel 6 Channel 7 Channel 8 Channel 9 Channel 10
POWER INPUT ~50-60Hz 30-1200VA MAX
CAUTION REPLACE WITH SAME TYPE FUSE
T10AH for 100-120V ac ~
UNBALANCED BALANCED
UNBALANCED BALANCED
UNBALANCED BALANCED
UNBALANCED BALANCED
UNBALANCED BALANCED
UNBALANCED BALANCED
UNBALANCED BALANCED
UNBALANCED
UNBALANCED
BALANCED
UNBALANCED BALANCED
BALANCED
TRIGGER
INPUT
5 - 30V
ac or dc
OFF ON
CHANNEL 6 CHANNEL 5 CHANNEL 4 CHANNEL 3 CHANNEL 2 CHANNEL 1
FAN
OUT
CHANNEL 10 CHANNEL 9 CHANNEL 8 CHANNEL 7
Channel 1
Stand By Hot
Channel 2 Channel 3 Channel 4 Channel 5 Channel 6 Channel 7 Channel 8 Channel 9 Channel 10
POWER INPUT ~50-60Hz 30-1200VA MAX
CAUTION REPLACE WITH SAME TYPE FUSE
T10AH for 100-120V ac ~
UNBALANCED BALANCED
UNBALANCED BALANCED
UNBALANCED BALANCED
UNBALANCED BALANCED
UNBALANCED BALANCED
UNBALANCED BALANCED
UNBALANCED BALANCED
UNBALANCED
UNBALANCED
BALANCED
UNBALANCED BALANCED
BALANCED
TRIGGER
INPUT
5 - 30V
ac or dc
C50 Rear Panel (above) and front panel with acrylic cover removed (below)
CONNECTING THE C50
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Meridian C50 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Meridian C50 in the language / languages: English as an attachment in your email.

The manual is 0,62 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info