494821
6
Zoom out
Zoom in
Previous page
1/8
Next page
8
1.Make sure that the TV is ON.
2.Hold down the and
keys simultaneously until
the light indicator starts to
flash indicating that the
remote control is in
programming mode.
3. Press key four times
then point the remote
control at the appliance.
Press and release the
key slowly several times.
STOP when your TV goes
OFF.
4.When your TV is OFF, press
the and keys
simultaneously. When you
release the keys, three
flashes indicate that the
search operation has been
completed correctly.
5.
IF YOU DO NOT HAVE THE
PROGRAMME SELECTION
KEYS ON YOUR ORIGINAL
REMOTE CONTROL
If your remote control does
not have the programme
selection keys (e.g. / ,
+/-, CH+/-..etc) once you
have programmed Mycro,
you can still select the
programmes from 0 to 9, as
follows:
SET-UP
Read these instructions carefully before programming
your remote control!
To use the remote control with your TV, you must first
program Mycro as described below. You can also visit our
Internet site www.meliconi.com to have access to interactive
instructions for easier and faster
remote control programming.
PROGRAMMING YOUR REMOTE CONTROL
Hold down the and
keys simultaneously until
the light indicator starts to
flash indicating that the
remote control is in
programming mode.
Release the keys and
press 9 times within
12 seconds.
Three flashes indicate that
the operation has been
completed correctly.
Make sure you can change
programmes from 0 to 9
using the and keys.
If not, repeat the search
operation, starting from
point 2.
Additional check
Check that all 7 keys are
operating correctly. If the
commands work incorrectly
or erratically, you have
probably entered a code for a
similar but different remote
control.
In this case, repeat the search
procedure from point 2 until
all keys respond correctly to
the commands sent.
Identify and take note of the TV code which you have
searched for, following the code noting procedure
(see "PROGRAMMED CODE NOTING" section).
M9996557 Opuscolo Mycro 17 Lingue B_N 88x198.qxd 12-
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Meliconi Mycro at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Meliconi Mycro in the language / languages: English, Italian as an attachment in your email.

The manual is 0,36 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info