673534
21
Zoom out
Zoom in
Previous page
1/21
Next page
21
Before Contacting Authorized Dealer
Ensure that the appliance is plugged in the outlet
and that the fuses are OK.
If the Lighting Does Not Operate:
Ensure that the appliance is plugged in the outlet
and that the fuses are OK.
• Check the bulbs. Always unplug the appliance
during this check. Tighten if the bulbs are loosened;
you may replace them if they do not turn on although
you have tightened them.
Possible Faults and Things To Do Before
Contacting the Service:
A) If the appliance does not operate
anyway:
- Check the fuse that the appliance is connected and
main fuse of your home.
- Check whether the hood is plugged and whether
the plug is fully seated on the outlet.
B) If the performance of the appliance is
not enough or operates loudly:
- Is the outlet diameter of the flue adequate? (min.
120 mm).
- Are metal filters clean? Check it.
- Ensure that the carbon filters are not older than 6
months if you are using the hood flueless.
- Make sure that your kitchen is adequately ventilated
to ensure the air flow.
Contact authorized service if the performance of
your appliance does not still satisfy you.
If the hood does not operate:
Before contacting the service:
Ensure that plug is installed on the outlet and that the
power fuse in the installation is OK; do not perform any
operations that may damage the appliance. Check
your appliance as per Table 1 before contacting the
service. Contact your dealer or nearest authorized
service if the problem is resumed.
Replacement of Glow Bulbs
Disconnect the hood from mains.
Remove the aluminum cartridge filter. Remove
the faulty bulb and replace with a new one with the
same rating. (Lamps may burn your hand when they
are hot, wait until they are cooled off.) Figure 17
Figure 17
Check electric connection(Voltage of t
electric network should be between
cooker hood should be connected to
Check motor switch (Motor switch should
on position)
Check motor switch (Motor switch should
on position)
Check aluminum filter(Aluminum
Filter should be washed once a mont
normal
conditions.)
Check lamps(Lamps should be firm.)
Check outlet (Outlet should be open)
Check Carbon Filter (Carbon filter
replaced with a new one each 2-3 months at
mod e ls with Carbon F i lter at
conditions)
Cooker-hood does not work
Illumination Lamp does not work
Cooker-hoods air suction is weak
Cooker-hood does not direct air out
(at places without chimney)
Table 1
TECHNICAL SPECIFICATIONS
Feeding Voltage
220-2 0 V 50Hz4
Motor Isolation Class
Isolation Class
F
CLASS I
REPLACING THE LAMPS
Disconnect the hood from mains.
*Remove the power connection of LED lamp.
*Press on the lamp with your hand to remove the
lamps.
*Remove the adhesive tape
around the lamp frame from the
body plate.
* Before placing the new LED
bulb, remove the protective foil
on the frame and stick it on its
position on the appliance body.
Replacement of Glow Bulbs
Disconnect the hood from mains. Remove the
aluminum cartridge filter.
Remove the faulty bulb and replace with a new one
with the same rating. (Lamps may burn your hand
when they are hot, wait until they are cooled off.)
In order to replace the lamp, remove the glass cover
on the lamp with an object that would not scratch the
surface of the appliance as shown in Figure 16.
Pull down and remove the faulty lamp and replace
with a new one.
Figure 16
21


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Meireles MEP 191XN at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Meireles MEP 191XN in the language / languages: English, Portuguese as an attachment in your email.

The manual is 2,83 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info