551352
17
Zoom out
Zoom in
Previous page
1/19
Next page
11ENGLISH ENGLISH
14
15
Firmware Update
When the frequency is switched off, on which the antenna idendifiziert the satellite, you
must update the firmware of the control unit.
The current firmware version of the control unit, you can read on the bottom of the
screen in the first 3 seconds after switching on.
Please check our website for the latest firmware version.
Preparing the SD card:
Before you use the SD card, format it to „FAT32“
After you format the SD card, copy the new software on it.
Update process:
1. Turn off the controller.
2. Insert the SD card into the slot on the rear side of the control unit.
3. Turn on the control unit. The following will appear in the display:
4. After the software is copied, the following message appears:
5. Now switch off the control unit and remove the SD card.
6. Turn on the control unit again. The firmware is updated now.
SD CARD DETECTED
WRITING SOFTWARE
LOAD COMPLETE
SD
CARD
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Megasat Shipman GPS-AutoSkew at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Megasat Shipman GPS-AutoSkew in the language / languages: English, German as an attachment in your email.

The manual is 1,52 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info