694355
44
Zoom out
Zoom in
Previous page
1/46
Next page
INSTALLATION AND USE MANUAL
Chapter 7
page 44
Maintenance and cleaning
Technical service MCZ S.p.A. all rights reserved - Reproduction prohibited
Never clean the refractory material with a damp cloth
or anything else, as it may be stained.
Use a dry paintbrush if necessary to remove heavy
soot build-up.
If the Alutec does not whiten, it is not to be
considered as a defect in light of the warnings and
instructions above.
7.1.4. Lubrication and routine maintenance of the
extensible guides
All of the doors of the fireplace stoves are mounted on extensible
ballbearing guides that ensure a robust, sturdy system that provides
silent movement.
Prolonged use and the heat of the fireplace stove gradually depletes the
lubricant in the guides. This will cause them to become less efficient
and noisier.
If necessary, periodically grease both runners as follows:
Pull open the frame liner and extract the door so you can see
the tracks of the guide.
Using the provided grease gun, apply two drops of grease,
about 5 mm in diameter, at the highest visible point of the
runners. Do not exceed the recommended amount!
Perform this operation on both guides. Keep in mind that the
total amount of grease to be used is about 0.5ml (see
graduated scale on grease gun).
After lubrication:
Put the glue gun back and conserve it
Lower and raise the door completely at least 6 or 7 times so
that the grease is spread onto all of the other components of
the guides to complete lubrication. You should notice a
substantial improvement in ease of movement and noise
reduction.
It is advisable to carry out this operation at the end of
the season of use, or whenever the runners become
too noisy.
Do not use other types of grease. If the grease gun
runs out, request an MCZ original replacement.
7.1.5. Maintenance of kit VF (if installed)
The maintenance of all electrical parts (fan, control
unit, etc.) must only be carried out with no electrical
power supplied and with the unit unplugged.
7.1.5.1.
Electric fan
Periodically, and at least at the end of each winter, it is advisable to
clean the fan blades, which may have suctioned up dust or other small
foreign bodies due to the static pressure exercised by the fan along the
air ducts.
Clean the fan blades only with compressed air or with a vacuum
cleaner. Take care not to damage the rotor or the fan blades.
Figure 15 Points to be greased with provided
grease gun
Downloaded from www.Manualslib.com manuals search engine
44


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for MCZ Forma Wood at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of MCZ Forma Wood in the language / languages: English as an attachment in your email.

The manual is 5,02 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info