Manual Maxi-Cosi priori xp (page 5 of 23) (English, German, Dutch, French, Italian, Portuguese, Spanish)

368177

Zoom out

Zoom in

1/23

Instructions for useInstructions for use

• The design of the cover may differ.If the cover on your seat has Velcro on the side seam on the back (28), you can

leave the entire belt system in place in the shell. You only need to open the Velcro and then follow the instructions for

removing the cover.

Removing the cover and belt pads

• Make sure that the seat buckle is locked in order to prevent the belts from twisting.

• The belt clamping handle must be locked, i.e. positioned against the base.

• Loosen the shoulder belts. See "Adjusting the height of the shoulder belts".

• Place the Maxi-Cosi Priori XP in the sleeping position and open the belt guard door (29).

• Remove the shoulder belts from the belt yoke (30).

• Tilt the clasp on the belt pad and pull it together with the shoulder belt through the belt slots. This is easiest to do in

the uppermost vertical section (31).

• Remove both belt hooks by pushing the tab on the back of the seat downwards (32).

• Loosen the cover on all sides (33). Open the belt buckle.

• Pull the belts, belt pads, buckle sections and seat buckle through the openings in the cover.

• Now remove the cover. Important: Be careful when removing the cover around the edge of the release button (34).

• Slide the belt pads off the belts (35).

Replacing the cover and belt pads

• First slide both buckle sections together and lock into the belt buckle.

• Slide the shoulder belts through the clean belt pads ensuring that the textured side of the belt pad is facing

downwards. Push the shoulder belts through the large opening of the clasp. Important: Make sure the shoulder belts

are on top of the belt pad strap (36).

• Open the buckle and feed the buckle, shoulder belts and buckle parts through the openings in the cover (37).

• Place the cover over the edges of the release button and around the adjusting handle and secure it onto the cover

pins (38).

• "Click" both belt hooks into position (39) and check to make sure they are securely fastened.

• Secure the shoulder belt clasps in the belt slots at the desired height (40/41).

• Attach the shoulder belts to the belt yoke. Important: The red stitching on the shoulder belts and belt yoke must be

facing the shell (42). If not, this means the belts are twisted.

• Close the belt guard door (43).

• Fasten the belt buckle and close the flap on the cover (44) and check the functioning of the adjustment system.

Checklist

Read through this checklist before every journey!

• Check to make sure the Maxi-Cosi Priori XP is securely fastened with the seat belt and that the clamping handle is

locked.

• Check to make sure the shoulder belts are at the proper height.

• Check to make sure your child is fastened securely and that the buckle is locked properly.

• Check regularly that the belt in the Maxi-Cosi Priori XP is not damaged. If it is damaged, do not use the car seat under

any circumstances and contact your supplier or importer (see address list on the back of the instruction manual).

• If you have any questions, please contact your supplier. Make sure that you have the following details on hand:

- Serial number at the bottom of the orange sticker (on the back of the Maxi-Cosi Priori XP).

- Make and type of vehicle and seat on which the Maxi-Cosi Priori XP is being used.

- Your child’s age and weight.

Handy tips

• The belt tensioner does not open: Place the shell in the sleeping position first.

• The child sits on the belts when placed in the Maxi-Cosi Priori XP: Drape the belts over the belt hooks and hook belt

pad over lip by release button.

• Now return the handle to its original position (click) making sure it rests against the base (12). The belt tensioner

tightens the seat belt even further. The belt tensioner should now be positioned between both belt hooks on the lap

belt (13).

• You can now adjust the shell of the Maxi-Cosi Priori XP into the desired position.

Placing your child in the Maxi-Cosi Priori XP

• Loosen the shoulder belts by pressing the release button and pulling the shoulder belts towards you (14). Important:

Do not pull on the belt pads when doing so.

• Open the belt buckle (15) and drape the belts over the hooks on the shell (16).

• Pull the buckle forwards and hook the belt pad over lip (17).

• Position your child comfortably with his/her back against the shell (18) and make sure that there are no toys or other

hard objects in the shell.

• Slide buckle tongue sections together and insert them into the buckle (19).

• Position the lap belt as low as possible to ensure the hips sit firmly in the seat.

• Pull the shoulder belts tight (20/1) and pull the remaining slack out of the belt system by pulling the belts tight using

the adjuster belt (20/2).

IMPORTANT!

• The tighter the belts fit around your child, the better the protection. You should be able to fit only one finger between

the belts and your child.

• The textured side of the belt pads must be placed on your child’s shoulders.

• The belts should never be twisted.

• If you are unable to click the buckle sections into the buckle, unblock the buckle by pressing the red button and try

again.

• If you are not able to fasten the seat belt system properly or pull it tight, contact your supplier immediately. Do not

use the Maxi-Cosi Priori XP under any circumstances!

Adjusting the height of the shoulder belts

The correct belt height of the shoulder belts is attained when the belt disappears into the shell slightly above the

shoulder of the child. Make sure that the shoulder belts fit properly over the shoulders of the child (21).

• Loosen the shoulder belts by pressing the release button and pulling the shoulder belts towards you as far as

possible (14) Important: Do not pull the belt pads when doing so.

• Lift up the flap on the cover by the shoulder belt slots (22).

• To make the adjustment easier, pull the shoulder belts on top of the belt pad forward into a loop, loosening them (23).

• Next, push the loop back through the opening (24).

• Slide the shoulder belt and the belt pad strap through the slot together into the next position (25). Make sure that the

shoulder belt is positioned on top of the belt pad strap in the new position (26). Always do this on both sides.

• Pull the shoulder belts tight by pulling on the belts under the belt pads (26).

• Place the flap back in position and thread the belt pads through the correct slots in the flap and secure them with the

Velcro (27).

• Check whether you are able to use the belts and ensure they are not twisted.

Maintenance, removing the cover and belt pads

Remove the Maxi-Cosi Priori XP from the car before carrying out any of the following.

• The seat may be cleaned with lukewarm water and a gentle soap. Do not use abrasive detergents.

• The cover and the belt pads must be washed by hand at a maximum temperature of 30

C. Do not use a dryer. Also

see washing instructions.

• The belt buckle may be cleaned with warm water. Do not lubricate.

• It is advisable to buy an extra cover when you purchase the Maxi-Cosi Priori XP, so that you can use the Maxi-Cosi

Priori XP at all times, such as when the cover has to be cleaned (or dried).

gba-priori-1-xp-624-bw:gba-priori-1-xp-624-bw 03-10-2008 14:37 Pagina 10

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Maxi-Cosi priori xp in the language / languages: English, German, Dutch, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 1,82 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Maxi-Cosi priori xp Manual

Product: