588485
6
Zoom out
Zoom in
Previous page
1/64
Next page
en
CZ
DE
DK
EE
ES
FI
FR
GB
HR
HU
IT
LT
LV
NL
NO
PL
RO
RU
SE
SI
SK
UA
SE
SI
SK
TR
UA
Rear FIG. 3
6. Air Filter/ Air inlet
7. Water Tank
8. Power cable
5. OPERATION
1. Plug the unit into a correct mains socket. (Please refer to
the rating label at the rear of the unit.)
2. Press button ON/OFF to turn on the unit. The compres-
sor will start to work in continuous mode.
3. To turn off the unit, press button ON/OFF again.
6. DRAINAGE
While the water tank is full, the compressor will stop for
self-protection and the water full indicator will turn into red.
To move the water tank, pull it out squarely from the unit.
After empting the water tank, place the water tank into spa-
ce. Make sure it is properly positioned, in order for the ’wa-
ter full’ sign to go out and your dehumidier is operating.
Please note, in case, the water tank has not been positio-
ned well, the water full indicator will turn into red.
CONTINUOUS DRAINAGE
When the dehumidier is operated at very high humidity
levels, the water tank will require more frequent drainage.
In this situation, it may be more convenient to set the unit
up for continuous drainage with the following procedures:
1. Pull out the water tank (FIG. 4).
2. Connect the drain hole with water tube of inner diame-
ter: 11 mm. The water tube is not supplied with the unit
(FIG. 5).
3. Ensure the water will always drain away freely and the
tube will remain in right place. Note! In very cold weather
conditions, precautions should be taken to prevent the wa-
ter tube from freezing.
4. Put the water tank back to its position (FIG. 6).
7. MAINTENANCE
Always unplug the unit from the mains before carrying out
any maintenance or cleaning of the unit.
CLEANING THE BODY
Use soft cloth to wipe the unit clean.
Don’t ever use volatile chemicals, gasoline, detergents,
chemically treated clothes, or other cleansing solutions.
These all could possibly hurt the cabinet.
CLEANING THE FILTER
This dehumidier is equipped with 2 lters (FIG. 7):
1. ANTI-DUST FILTER
Extract the lter holder, remove the active carbon lter.
Use a vacuum cleaner or tap the lter lightly for easy clea-
ning. If the lter is particularly dirty, use warm water with
a small amount of a small amount of medium strength
detergent.
Make sure the lter is completely dry before replacing.
Do not expose the lter to sunlight.
2. ACTIVE CARBON FITLER (for capturing the particles
of dust suspended in the air and preventing the produc-
tion of bacteria.)
The active carbon lter placed under the anti-dust lter is
not washable. Its life span is variable and depends on the
ambient conditions where the unit is used. The lter should
be checked periodically and replaced if necessary.
STORAGE
If not use the unit for an extended period of time. Please:
Turing the unit off, unplug and tidy AC cord.
Completely empty the water tank and wipe it clean.
Cover the unit and store where it will not receive direct
sunlight.
8. TROUBLE SHOOTING
THE UNIT DOES NOT OPERATE:
Is the unit plugged in?
Is the house electricity on?
Is the room temperature below 5OC or above 35OC? If
so, then it is out of the working range of the unit.
Ensure the humidistat (or ON/OFF switch) is turned
on.
Check the water tank is positioned properly in the unit
and it is not full.
Make sure the air inlet and outlet are not obstructed.
THE UNIT SEEMS TO DO NOTHING:
Is the lter dusty, contaminated ?
Is the air intake or outlet blocked up?
Is the room humidity already quite low?
THE UNIT SEEMS TO DO LITTLE:
Are too many windows or doors open?
Is there something in the room producing lots of humi-
dity?
THE UNIT IS TOO NOISY:
Check whether the unit is sitting on a level surface.
THE UNIT IS LEAKING:
Make sure the unit is in good shape.
If you are not using continuous drainage, make sure the
rubber plug (at the bottom of the unit) is in its position.
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for master DH 710 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of master DH 710 in the language / languages: All languages as an attachment in your email.

The manual is 2,04 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info