If your receiver should not perform as expected, consult the table below to see if the problem can be corrected before seeking help from your dealer or our
service organization.
PROBLEMPOSSIBLE CAUSEREMEDY
No power• The AC input cord is disconnected.•Connect cord securely.
•Poor connection at AC wall outlet or the outlet•Check the outlet using lamp or other appliance.
is inactive.
The sound is shut off.•The speaker cables are shorted.•Check the speaker connections.
No sound from the speakers.•The speaker cables are disconnected.•Check the speaker connections.
•The master volume is adjusted too low.•Adjust the master volume and center, surr.vol.
•The surround volume is adgusted too low.
•The center volume is adgusted too low.
•The Mute button is pressed to ON.•Press the MUTE button to cancel the muting
effect.
•The SPEAKER switches are not pressed correctly.•Press the SPEAKER switches to ON correctly.
•Incorrect selection of program source.•Select the desired program source correctly.
•Format of surround is different.•DISK of AC-3 format is used.
•Incorrect connections between the components.•Make connections correctly.
Sound is only heard from one of•The BALANCE control is set to one end.•Adjust the BALANCE control.
front speakers.•One of the connection cords is disconnected.•Connect the right and left connection cords
securely.
No sound from the rear speakers.•The sound field mode is not selected correctly•Select the desired sound field mode correctly.
or is set to off.
•The master volume and rear level are adjusted•Adjust the master volume and rear level.
too low.
•Monaural source is used, or source without•Change the playback source to the stereo or
surround information.surround source.
No sound from the center speaker.•The DTS, Dolby Digital, pro logic, 3stereo mode is•Select the desired mode.
not selected.
•The center mode is set to the NONE mode.•Set to the NORMAL or WIDE mode.
•The master volume and center level are adjusted•Adjust the master volume and center level.
too low.
The remote control unit does not•Batteries are not loaded or exhausted.•Replace the with new batteries.
operate.•The remote sensor is obstructed.•Remove the obstacle from the remote sensor.
Not receiving the stations.•No antenna is connected.•Connect an antenna.
•The desired station frequency is not tuned in.•Tune in the desired station frequency.
Not receiving the preset stations.•An incorrect station frequency has been•Memorized the correct station frequency.
memorized.
•The memorized stations are cleared.•Memorize the stations again.
Poor FM reception.•No antenna is connected.•Connect an antenna.
•The antenna is not positioned for the best•Change the position of the antenna.
reception.Route as high as possible.
Continuous hissing noise during FM•Weak signal.•Change the position of the antenna.
reception, especially when a stereo•In areas remote from the transmitter, a 5 to
broadcast is received.8 element antenna designed exclusively for
FM is suggested.
Continuous or intermittent hissing•Noise is caused by motors, fluorescent•Keep the receiver away from noise sources.
noise during AM reception, especiallylamps or lightning, etc.
at night.•Install an outdoor AM antenna.
A hum can be heard during AM•Position the AC input cord away from the
Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.
Product:
Forumrules
To achieve meaningful questions, we apply the following rules:
First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.
Register
Register getting emails for Marantz SR-5000 at:
new questions and answers
new manuals
You will receive an email to register for one or both of the options.
Get your user manual by e-mail
Enter your email address to receive the manual of Marantz SR-5000 in the language / languages: English as an attachment in your email.
The manual is 0,15 mb in size.
You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.
If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.
The email address you have provided is not correct.
Please check the email address and correct it.
Your question is posted on this page
Would you like to receive an email when new answers and questions are posted? Please enter your email address.
