474192
4
Zoom out
Zoom in
Previous page
1/4
Next page
MAC KC 1 (05/2002) 4/4
FOUTBEPALING
Als de MAC KC 1 correct geïnstalleerd is moet de gele LED in de
decoder branden. Het kan 60 sec. duren; na het aanschakelen,
vooraleer de LED oplicht.
De gele LED duidt aan dat de signaaloverdracht van het klavier naar
de decoder werkt.
Als de installatie na het aanschakelen niet correct werkt, kan men
volgende punten nagaan.
1. Licht bij elke toetsindruk de gele LED op het klavier op, evenals
de andere LED’s zoals beschreven in de programmering ?
Indien neen :
- Ligt de spanning aan ?
- Is de verbinding tussen de decoder en het klavier in orde ?
(op de klemmen van het klavier kan een spanning van 12V
DC gemeten worden.)
Indien ja :
- dan is het klavier in orde, anders moet het klavier vervangen
worden.
2. De gele LED in de decoder brandt niet als 60 sec. na het
aanschakelen van de installatie de toets met het belsymbool
ingedrukt wordt, hoewel het klavier wel goed werkt.
- De decoder is defect en moet hersteld worden.
3. De gele LED in de decoder brandt, maar gaat uit als een geldige
openingscode ingegeven wordt :
- De sleutelcode in de decoder en het klavier stemmen niet overeen.
- De sleutelcode van de decoder moet in het klavier
geprogrammeerd worden
PROBLEMES
Si le MAC KC 1 est installé correct, la LED jaune dans le décodeur doit
s’allumer. Cela prend parfois 60 sec. Après la mise en marche avant
que la LED s’allume. La LED jaune signifie si le décodeur reçoit bien
les signaux du clavier.
Quand l’installation ne fonctionne pas bien au moment de la mise en
marche, on peut vérifier les points suivants.
1. Est-ce que la LED jaune s’allume quand on appuie sur une
touche ? Est-ce que les autres LED’s s’allument comme déscrit
dans la programmation ?
Si non :
- Est-ce que la tension d’alimentation est activée ?
- Est-ce que la connection entre le décodeur et le clavier est
bien fait ? (Sur les bornes du clavier on peut mesurer une
tension de 12 V DC).
Si oui :
- Le clavier est en ordre, autrement le clavier doit être changé.
2. Quand la LED jaune dans le décodeur ne s’allume pas quand on
appuie sur la touche de sonnette 60 secondes après la mise en
marche, néanmoins le clavier marche bien.
3. La LED jaune dans le décodeur s’allume mais s’éteint quand on
introduit le code d’accès correct.
- Le code à clef dans le décodeur et le clavier ne correspondent
pas.
- Le code à clef du décodeur doit être programmé dans le clavier.
PROGRAMMATION CODE D’ACCES
1) P
2) CODE MAITRE
3) PETITE CLOCHE
4) NOUVEAU CODE (max. 6 chiffres)
5) PLACE OCCUPE PAR LE CODE (1-5)
6) PETITE CLOCHE
PROGRAMMATION DU CODE MAITRE
1) P
2) CODE MAITRE
3) PETITE CLOCHE
4) P
5) NOUVEAU CODE MAITRE
6) PETITE CLOCHE
PROGRAMMATION DU CODE CLE
1) P
2) CODE MAITRE
3) PETITE CLOCHE
4) P
5) P
6) CODE CLE
7) PETITE CLOCHE
RESET
1) COUPER L’ALIMENTATION
2) PLACER UN AIMANT SUR LA TOUCHE 2
3) REMETTRE L’ALIMENTATION
4) CODE D’ACCES: 1234
CODE MAITRE : 11111
CODE CLE A PROGRAMMER
(SE TROUVE SUR LE TRANSFO BLEU DU
DECODEUR)
1) P
2) MASTERCODE
3) KLOKJE
4) NIEUWE CODE (max. 6 cijfers)
5) GEHEUGENPLAATS (1-5)
6) KLOKJE
PROGRAMMATIE MASTERCODE
1) P
2) MASTERCODE
3) KLOKJE
4) P
5) NIEUWE MASTERCODE
6) KLOKJE
PROGRAMMATIE SLEUTELCODE
1) P
2) MASTERCODE
3) KLOKJE
4) P
5) P
6) SLEUTELCODE
7) KLOKJE
RESET
1) STROOM AFLEGGEN
2) MAGNEET OP TOETS 2 PLAATSEN
3) STROOM TERUG AANLEGGEN
4) TOEGANGSCODE : 1234
MASTERCODE : 11111
SLEUTELCODE PROGRAMMEREN
(OP BLAUWE TRANSFO IN DECODER)
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for MAC KC1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of MAC KC1 in the language / languages: Dutch, French as an attachment in your email.

The manual is 0,12 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info