-
OUTDOOR LIGHT WITH CAMERA
Reply Report abuse
"PIR event" and "Motion detected" are unable to control a scenario.
Everything happens as if no detection was carried out.
However, movements are well reported and recordings following the movements are well triggered.
Several resets and several reinstallations of the camera do not solve the problem (the firmware version is V2.1.32.367)."
Does everyone have the same problem and the same firmware ?
Submitted on 21-12-2022 at 10:20 -
"PIR event" and "Motion detected" are unable to control a scenario. Everything happens as if no detection was carried out. However, movements are well reported and recordings following the movements are well triggered. Several resets and several reinstallations of the camera do not solve the problem (the firmware version is V2.1.32.367)."
Reply Report abuse
Submitted on 21-12-2022 at 09:24-
I realize that I forgot to indicate the reference of the camera:
Vote up Report abuse
OUTDOOR LIGHT WITH CAMERA Answered on 21-12-2022 at 09:30
-
-
When I use the movement detector... to switch the lamp on... it works... however I want the lamp to switch off again after 2 minutes... initially that works... but after a while it doesn't switch off any more...
Reply Report abuse
Also if the lamp is still within the 2 minutes switched on... and there is a movement... it doesn't restitch or prolong the timer...
Are there ways to make this more precise and working all the time...?
Submitted on 20-9-2020 at 15:25