599461
2
Zoom out
Zoom in
Previous page
1/8
Next page
2
Tools and Supplies
Recommended tools include pliers and a athead screwdriver. If you need to
route the module connector through a bulkhead, you will need a drill and a 7/8”
(22 mm) drill bit. If you are mounting the module directly to at, horizontal
surface, you will need a #31 (3 mm) drill bit for the screw holes.
Mounting the LGC Module
The GPS module can be mounted on any at surface as long as there is room
behind the mounting surface for the screws. The optional pole mount adapter
lets you mount the antenna on a pole or swivel mount that uses standard marine
1”-14 threads.
Surface Mount
The GPS module can be installed on any at surface that is at least 3-1/2” (90
mm) wide. Make sure a clear, unobstructed view of the sky is available at the
selected location.
Once you have determined the mounting location, drill the screw holes. The
screws supplied with this unit are about 1-1/8” long (4 mm x 30 mm). Drill .120
diameter (3 mm) holes for the mounting screws.
If you need to route the cable through the mounting surface, drill a 7/8” (22
mm) hole for the cable’s connector. The notch in the antenna housing allows
the cable to pass through, if desired, instead of routing it down through the
mounting surface.
After drilling the holes, pass the O-ring over the cable and press it into the
groove on the bottom of the antenna housing.
Now attach the antenna to the mounting surface, using 4 mm screws and lock
washers. Route the cable to where it connects to the network and plug it in. The
installation is complete.
CAUTION: Do not mount the GPS module in the direct
path of a radar antenna’s beam. Radar radiates high-energy
signals that can interfere with GPS signal reception.
!
2


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Lowrance LGC-4000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Lowrance LGC-4000 in the language / languages: English as an attachment in your email.

The manual is 0,95 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info