522485
4
Zoom out
Zoom in
Previous page
1/22
Next page
4
Traditional Sonar
D. Attaching Transducer to Transom
1. Adjust the transducer so its face is
parallel with the ground and its center
line is even with the bottom of the boat
hull.
2. Hold the transducer and bracket
assembly against the transom. When the
transducer and bracket are properly aligned
mark its position on the hull.
3. Drill the mounting holes for the transducer
bracket. Use a #29 bit (for the #10 screws).
Routing cables
When mounting your transducer, make sure to
leave some slack in the cable near the transducer. If
you need to drill a hole in the transom to pass the
connector through, the hole size will depend on
the connector on the end of the transducer’s cable.
E. Make test run to determine results
After the transducer is installed make a test run to
ensure the transducer is installed properly. Use the
Transducer face must be
parallel with the ground
Transom
Bottom of
hull
Run the cable over
the bolt and through
the bracket.
Do not over tighten the lock nut;
otherwise transducer may not kick-
up if it strikes an object.
0.TWEETY INSTALL_SONAR_DSI.indd 4 9/14/2011 11:55:31 PM
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Lowrance Elite 5 DSI at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Lowrance Elite 5 DSI in the language / languages: English as an attachment in your email.

The manual is 2,77 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Lowrance Elite 5 DSI

Lowrance Elite 5 DSI User Manual - English - 47 pages

Lowrance Elite 5 DSI User Manual - German - 45 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info