Manual Lorus YT57 (page 1 of 3) (English)

593905

Zoom out

Zoom in

1/3

MON

1. [For Cal. YT57]

Pull out the crown to the first click and

turn it until the previous day’s date ap-

pears.

[For Cal. YT58]

Pull out the crown to the first click and

turn it clockwise until the previous day’s

date appears. Then, turn the crown coun-

terclockwise until the previous day of the

week appears.

2. Pull out the crown to the second click

when the second hand is at the 12 o’clock

position.

3. Turn the crown to set the desired date

(and day for Cal. YT58).

4. Turn the crown to set the hour and minute

hands to the desired time.

5. Push the crown back in to the normal po-

sition in accordance with a time signal.

INSTRUCTION MANUAL

CAL. YT57 (RAR SERIES)

CAL. YT58 (RD2 SERIES)

NREYT57C

05-00

Unlike mechanical watches or con-

ventional quartz watches, LORUS

KINETIC

requires no windup springs

or batteries. Instead, it utilizes

the movement of the wearer as its

power source.

■ DISPLAY AND CROWN

Hour hand Minute hand

Crown

Second hand

Normal position

First click

Second

click

■ TIME/CALENDAR SETTING

Hour hand

Minute hand

Crown

Second hand

Normal position

First click

Second

click

Date

• Before setting the time, make sure that the

second hand is moving at one-second in-

tervals.

When the watch was purchased,

you may find the crown pulled out

to the second click. In that case,

push it back in to the normal po-

sition, and follow the instructions

below.

[Cal. YT57]

Hour hand Minute hand

Crown

Second hand

Normal position

First click

Second

click

Date

[Cal. YT58]

Day

Day (only for

Cal. YT58)

Notes:

1. For Cal. YT57, do not set the date between

9:00 p.m. and 1:00 a.m. For Cal. YT58, do

not set the day/date between 9:00 p.m.

and 3:00 a.m. Otherwise, the calendar

may not change properly. If it is neces-

sary to set the calendar during that time

period, first change the time to any time

outside it, set the calendar and then reset

the correct time.

2. When setting the hour hand, check that

AM/PM is correctly set. The watch is so

designed that the calendar changes once

a day.

3. When setting the minute hand, advance it

4 to 5 minutes ahead of the desired time

and then turn it back to the exact minute.

4. It is necessary to adjust the date at the

end of February and 30-day months.

■ POWER RESERVE IN YOUR LORUS

KINETIC WATCH

• The electric energy generated while the

watch is worn on your wrist is stored in the

KINETIC ELECTRICITY STORAGE UNIT

(KINETIC E.S.U.). It is a power source

completely different from conventional batteries

for watches, and therefore, this watch does

not require battery replacement.

• The watch has been charged fully at the

factory. Normally, therefore, it is not nec-

essary to charge the watch by swinging it.

If you should find the second hand being at

a stop, however, charge the watch follow-

ing the procedure in “How to charge the

watch”.

1. When the watch stops completely, a few

swings will start the second hand moving

at two-second intervals. The watch, how-

ever, will run down shortly, if left untouched.

2. Swing the watch approximately 100 times.

There will be about 12 hours of power

reserve available.

3. Then, wear the watch on your wrist.

* Even if the watch is worn on your wrist, it

will not be charged while your arm is not in

motion.

* It is recommended that, before worn on

your wrist, the watch be swung further un-

til one day of power is reserved. As a guide-

line of recharging, an additional 200 swings,

about 300 swings in total, will reserve one

day of power. It is not necessary to charge

the watch fully, as it is charged automati-

cally while it is worn on your wrist.

POWER RESERVE

NUMBER OF SWINGS

100

300

1 day

6 month

FULL

12 hours

How to charge the watch

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Lorus YT57 in the language / languages: English as an attachment in your email.

The manual is 0,14 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Lorus YT57

Lorus YT57 User Manual - German - 16 pages

Lorus YT57 User Manual - Dutch - 16 pages

Lorus YT57 User Manual - French - 16 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Lorus YT57 Manual

Product: