593868
3
Zoom out
Zoom in
Previous page
1/4
Next page
Notes:
1. When the time function is displayed in the 24-
hour indication, the alarm is also displayed in
the 24-hour indication.
2. When setting the hour digits in the 12-hour
indication, check that “A” (AM)/“P” (PM) mark
is properly set.
3. If the watch is untouched in the alarm setting
display with the digits flashing, it will auto-
matically return to the alarm display in 2 to 3
minutes.
Engagement/Disengagement of
the Alarm
With each depression of button “C” in the alarm
display, the alarm is engaged and disengaged alternately.
The alarm rings at the designated time for 20
seconds and stop. To stop it manually, depress
button “A”, “B”, “C” or “D”.
Alarm engaged
Alarm disengaged
5. After all the adjustments are completed, de-
press button “B” to return to the alarm display.
The alarm mark and “ON” mark are automati-
cally displayed.
Turning on/off of the Hourly Time Signal
and Confirmation Sound; and Alarm Test
With each depression of button “C” in the time/
calendar display, the hourly time signal and
confirmation sound for the button operation are
turned on and off alternately.
Hourly time signal and confirmation
sound turned off
Hourly time signal and confirmation
sound turned on
The alarm can be tested by keeping buttons “C”
and “D” depressed in the time/calendar display.
* After the alarm sound is tested, be sure to check
turning on/off of the hourly time signal and
confirmation sound, as they are turned on and
off alternately by depressing button “C”.
HOW TO USE THE SIGNAL FUNCTION
CAUTION
Do not use the watch as a distress signal trans-
mitter as it is not designed for such purpose.
The signal light emitted from the watch may
not be perceived depending on such factors as
distance to the target and angle of the watch
face.
With a press of a button, 4 preset Morse code
messages can be given by light automatically. Messages
can also be given manually by turning on and off
the illuminating light.
1. Depress button “A” to show the distress signal
display.
2. Selection of the four preset messages and the
manual mode is made in the following order by
depressing button “C”.
“LL”
(ALL WELL)
→→
)
(
” (Manual mode)
“I”
REQUIRE
DOCTOR
“Y”
(YES)
“N”
(NO)
3. Depress button “D” to give a desired Morse
code message by light.
* The preset messages are given repeatedly
while the button is kept depressed.
* Once button “D” is depressed, the preset
message will be given to the end even if the
button is released before it is completed.
* When the manual mode is selected, the illuminating
light is turned on when button “D” is depressed,
and is turned off when it is released.
A
Message marks
A
B
Signal display
indicator
Current
time
Manual mode
mark
C
D
)(
Message
indicator
Duration
of
illumi-
nation
- – – - - – - - - – - -
WLEL
REQUIRE
DOCTOR
ALL WELL
YES
NO
Everything is
going well.
YES
(Affirmative)
NO
(Negative)
- –––
N
O
– - – – - - - -
– - - – – – – - – -
D
OC
TO
– – – – - – -
R
Y
I
LL
Meaning
3.2 seconds
3.0 seconds
9.0 seconds
4.0 seconds
The display remains illumi-
nated while the button is kept
depressed.
MANUAL
*Pattern of light illumination:
Long duration of illumination
- Short duration of illumination
N
Y
SE
Pattern of light
illumination
(Morse code)
Seriously in-
jured. Send
a doctor.
Mes-
sage
code
Pattern of Light Illumination
(Morse Code)
NOTE ON UNUSUAL DISPLAY
While in the time/calendar setting display, the
display as shown below will appear if both buttons
“C” and “D” are depressed at the same time. This
is not a malfunction. Depress button “A”, “B”, “C”
or “D” to return to the time/calendar display, and
then set the time/calendar again.
[All the segments lighting up]
LUMIBRITE WATCH
(dial, hands, buttons, case, bezel, straps, etc.)
If your watch is a LORUS LUMIBRITE watch, it
has following features.
LORUS LUMIBRITE watches absorb and store light
energy from natural and artificial light sources
and emit light in the dark. They are made of
environmentally friendly material, and therefore,
are harmless to human beings and the environment.
With a full charge, LORUS LUMIBRITE watches
glow in the dark hours longer than conventional
luminous watches of this type. If exposed to a
light of more than 500 lux (i.e., the brightness
of a typical office) for approximately 10 minutes,
or direct sunlight for 2 minutes, for example,
they will glow for 3 to 5 hours.
Since LORUS LUMIBRITE watches emit the light
they store, the brightness will decrease gradually
over time. The length of time they will glow
may also differ slightly depending on such factors
as the brightness of and distance from the light
source used to charge the watch.
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Lorus W820 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Lorus W820 in the language / languages: English as an attachment in your email.

The manual is 0,42 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info