29
NOITALLATSNI REWOLB ROF SNOITCURTSNI
NOTE: Set up as close to power source as possible. The product
should be periodically examined for potentially unsafe conditions
such as: damaged cord, plug, housing or parts, and that in the
event such damage is found, the product should not be used until
properly repaired. Never leave the blower outside in the rain or
exposed to the elements when not in use. When in use, do not
place the cord across traffi c areas, water or damp areas. The
blower should be placed on a stable surface and anchored per
product instructions. The power cord of the blower is equipped
with a Ground Faulty Current Interrupter (GFCI) plug.
gulP .noitisop ”FFO“ eht ni si hctiws rewolb eht taht erus ekaM )1
the blower into a properly grounded 110-120V GFCI outlet.
ot nottub ”TESER“ eht sserp ,deppirt neeb sah ICFG eht fI )2
restore power to the blower.
,esu retfA .eta flni ot ”NO“ ot rewolb eht fo hctiws rewop eht teS )3
turn the power to “OFF”.
gulp eht llup dna ylthgit ti pirg tluda na evah ,tcennocsid oT )4
from wall outlet.
snoitcurtsni eseht wollof ot eruliaF :GNINRAW
could result in serious injury or death.
• ADULT SET-UP AND SUPERVISION REQUIRED.
• Use only with Ground Fault Circuit Interrupt (GFCI) receptacle.
eb ot
dednetni ton si tI .ylno esu laitnediser rof si rewolb sihT •
used in commercial or industrial settings.
llirg eht hguorht tcejbo rehto yna ro slicnep ,sregn fi tresni reveN •
at ANY time.
eht retfa ,gulp ro droc degamad a htiw rewolb etarepo ton oD •
appliance malfunctions or has been dropped or damaged in any
manner.
elbamma fl ro/dna evisolpxe fo ecneserp eht ni etarepo ton oD •
fumes.
lortnoc deeps etats - dilos yna ot rewolb eht tcennoc reveN •
device.
rewolb siht esu ton od ,kcohs cirtcele ro er fi fo ksir eht e
cuder oT •
with any solid-state speed control device.
• WARNING - Electronic hazard - Do not use extension cords with
this product.
• Always unplug the blower before servicing.
• Outdoor use only.
YLLACIRTCELE :NOITUAC
OPERATED PRODUCT
ESREMMI TON OD ,KCOHS CIRTCELE TNEVERP OT - REGNAD
IN WATER. WIPE CLEAN WITH DAMP CLOTH.
SNOITCURTSNI ESEHT WOLLOF OT ERULIAF :GNINRAW
COULD RESULT IN SERIOUS INJURY OR DEATH. ADULT SET-
UP AND SUPERVISION REQUIRED.
MODEL FJ-30W
BLOWER SPECIFICATIONS: 120V (AC),
60 Hz, 5.5A, 660W
NOITUAC SELCATPECER DETCETORP ICFG NO YLNO ESU
GROUNDING INSTRUCTIONS FOR ALL GROUNDED, CORD-CONNECTED PRODUCTS
This product should be grounded. In the event of an electrical short circuit, grounding reduces the risk of electric shock by
providing an escape wire for the electric current. This product is equipped with a cord having a grounding wire with an ap-
propriate grounding plug. This plug must be plugged into an outlet that is properly installed and grounded in accordance with
all local codes and ordinances. DANGER - Improper installation of the grounding plug can result in a risk of electric shock.
If repair or replacement of the cord or plug is necessary, do not connect the grounding wire to either fl at blade terminal. The
wire with insulation having an outer surface that is green, with or without yellow stripes, is the grounding wire. Check with a
qualifi ed electrician or serviceman if the grounding instructions are not completely understood, or if in doubt as to whether
the product is properly grounded. Do not modify the plug provided; if it will not fi t the outlet, have the proper outlet installed
by a qualifi ed electrician. For a grounded, cord-connected product, rated less than 15 amperes and intended for use on a
nominal 110-120-volt supply circuit, these instructions should be followed. This product is for use on a nominal 110-120-
volt supply circuit, and has a grounding plug that looks like the plug illustrated in sketch A. Temporary adapters should not
be used. Do not use product until a properly grounded outlet (sketch A) can be installed by a qualifi ed electrician.
CAUTION: The blower is a high volume blower, and is capable of moving lots of air very quickly. Place the blower in
an area where it will not suck in dirt or leaves. Keep away from water and traffi c. Keep children away from the blower.
Only the blower supplied should be used for infl ation.
Safety Warnings: ELECTRICAL BLOWER
This blower is not a toy. Use under the direct supervision of a competent adult. Keep away from children.
READ AND SAVE THESE INSTRUCTIONS.
GROUNDING METHODS
Grounding
pin
DANGER
INSTRUCTIONS FOR BLOWER CLEANING AND STORAGE
Do not immerse the blower in water. Unplug the blower before cleaning. To clean: wipe with a damp cloth. The blower does not require
any lubrication and has no user serviceable parts. Do not attempt to service the blower. When not in use, store the blower indoors in a
dry place. Store the blower upright on a stable surface. Loosely coil the cord and place it beside the blower.
• Blower must be unplugged before servicing.
• Do not operate any fan with a damaged cord or plug. Discard fan or
return to an authorized service facility for examination and/or repair.
• Do not run cord under carpeting. Do not cover cord with throw rugs,
runners, or similar coverings. Do not route cord under furniture or
appliances. Arrange cord away from traffic area and where it will not
be tripped over.
efasnu yllaitnetop rof denimaxe yllacidoirep eb dluohs tcudorP •
conditions such as damaged cord, plug, housing, or parts, and that
in the even such damage is found, the product should not be used
until properly repaired. If these checks are not carried out, the toy
could overturn or otherwise become a hazard.
resu on sah dna noitacirbul yna eriuqer ton seod rewolb ehT •
serviceable parts. Do not attempt to service the blower.
.htolc pmad a htiw epiw ,naelc
oT .retaw ni naf eht esremmi ton oD •
fo eerf peek dna sgninepo tuptuo dna ekatni eht kcehc ylralugeR •
dirt, leaves, etc.
• When not in use, store the blower indoors in a dry place.
• Store the blower upright on a stable surface.
• Loosely coil the cord and place it beside the blower.
fifart ssorca droc eht ecalp ton od ,esu ni nehW • c areas, water or
damp areas.
egral gnivom fo elbapac si dna ,rewolb emulov hgih a si rewolb ehT •
volumes of air very quickly. Place the blower in an area where it will
not draw in dirt or leaves.
2
Repair Kit Instructions
WARNING: Repair patches must be applied by an adult only. KEEP OUT OF REACH OF CHILDREN.
REPAIR PATCH INSTRUCTION
1. Defl ate the item, clean the area and allow to dry thoroughly.
2. Cut a portion of the patch to the size needed and round the corners. (See Fig. 1 & 2).
3. Remove the adhesive backing from the patch material, position the patch over the damaged area and smooth out any bubbles.
4. Allow to sit for 30 minutes before re-infl ating.
WARNING: NOT A TOY. ADULT USE ONLY.
Repair kit. Keep away from children.
1
Instructions for
Bouncer Maintenance
Instructions for
Blower Maintenance
dna raew ot tcejbus si recnuob eht ,tcudorp roodtuo na sA •
deterioration. Inspect for signs of fabric failure; weak or torn
surfaces must be repaired promptly.
yrd a gnisu rewolb ro recnuob eht epiw :naelc tcudorp eht peek oT •
cloth or a cloth dampened with a neutral, non-infl ammable, non-
toxic cleaning and sanitizing solution or pure water.
.pu gnillor erofeb yrd ot wollA .tew derots eb reven dluohs tcudorP •
Disposal
rennam a hcus ni tnempiuqe eht fo esopsid dna elbmessasiD •
that no hazardous conditions exist at the time the equipment is
discarded.
fo elbapac retnec noitcelloc a ot denruter eb dluohs rewolB •
processing electrical/electronic waste.
