815353
3
Zoom out
Zoom in
Previous page
1/6
Next page
2
9
NOTE: Set up as close to power source as possible. The product
should be periodically examined for potentially unsafe conditions
such as: damaged cord, plug, housing or parts, and that in the
event such damage is found, the product should not be used until
properly repaired. Never leave the blower outside in the rain or
exposed to the elements when not in use. When in use, do not
place the cord across traffic areas, water or damp areas. The
blower should be placed on a stable surface and anchored per
product instructions. The power cord of the blower is equipped
with a Ground Faulty Circuit Interrupter (GFCI) plug.
1) Make sure that the blower switch is in the “OFF” position. Plug
the blower into a properly grounded 110-120V GFCI outlet.
2) If the GFCI has been tripped, press the “RESET” button to
restore power to the blower.
3) Set the power switch of the blower to “ON” to inflate. After use,
turn the power to “OFF.”
4) To disconnect, have an adult grip it tightly and pull the plug
from wall outlet.
OPERATED PRODUCT
MODEL RW-2LA
BLOWER SPECIFICATIONS: 115V (AC),
60 Hz, 4.8A, 552W
GROUNDING INSTRUCTIONS FOR ALL GROUNDED, CORD-CONNECTED PRODUCTS
This product should be grounded. In the event of an electrical short circuit, grounding reduces the risk of electric shock by
providing an escape wire for the electric circuit. This product is equipped with a cord having a grounding wire with an ap-
propriate grounding plug. This plug must be plugged into an outlet that is properly installed and grounded in accordance with
all local codes and ordinances. DANGER - Improper installation of the grounding plug can result in a risk of electric shock.
If repair or replacement of the cord or plug is necessary, do not connect the grounding wire to either at blade terminal. The
wire with insulation having an outer surface that is green, with or without yellow stripes, is the Grounding wire. Check with a
Qualified electrician or serviceman if the grounding instructions are not completely understood, or if in doubt as to whether
The product is properly grounded. Do not modify the plug provided; if it will not fit the outlet, have the proper outlet installed
by a qualified electrician. For a grounded, cord-connected product, rated less than 15 amperes and intended for use on a
nominal 110-120-volt supply circuit, these instructions should be followed. This product is for use on a nominal 110-120-
volt supply circuit, and has a grounding plug that looks like the plug illustrated in sketch A. Temporary adapters should not
be used. Do not use product until a properly grounded outlet (sketch A) can be installed by a qualified electrician.
CAUTION: The blower is a high volume blower, and is capable of moving lots of air very quickly. Place the blower in
an area where it will not suck in dirt or leaves. Keep away from water and trafc. Keep children away from the blower.
Only the blower supplied should be used for ination.
Safety Warnings: ELECTRICAL BLOWER
This blower is not a toy. Use under the direct supervision of a competent adult. Keep away from children.
THIS INSTRUCTION BOOKLET CONTAINS IMPORTANT SAFETY INFORMATION. PLEASE READ AND KEEP FOR FUTURE REFERENCE.
T
S
ET
TE
SER
GROUNDING METHODS
Grounding
pin
DANGER
INSTRUCTIONS FOR BLOWER CLEANING AND STORAGE
Do not immerse the blower in water. Unplug the blower before cleaning. To clean: wipe with a damp cloth. The blower does not require
any lubrication and has no user serviceable parts. Do not attempt to service the blower. When not in use, store the blower indoors in a
dry place. Store the blower upright on a stable surface. Loosely coil the cord and place it beside the blower.
IMPORTANT - Inflatable waterpark MUST be drained of all water and be COMPLETELY DRY before storage in order to avoid mold and mildew.
DO NOT fold and store waterpark if any moisture remains.
IMPORTANT - All children MUST EXIT the waterpark before deflation or draining water.
IMPORTANT - For best results, 2-4 people should drain and move the waterpark.
Draining & Deation
Turn o
the garden hose
Disconnect
2
Turn off the garden hose
and disconnect it from the
Clear Plastic Tubing.
4
Remove stakes and drag the waterpark
away from the drained water to a dry area.
8Untie the drawstring from the short Outlet Tube and
allow the waterpark to fully deate. Remove the
Hose Assembly and wrap it up with no kinks.
Remove and drain the Hose
Assembly from the waterpark.
6Leave the waterpark inflated
until all remaining water has
evaporated and the water
park is dry. This may take 2
hours or more depending on
weather conditions.
As the waterpark deflates, water will find
the lowest point and drain from the
collapsing pool walls.
Lift the bottom of pool from one side to
the other to let the remaining water drain.
3
CAUTION: ELECTRICALLY
INSTRUCTIONS FOR BLOWER INSTALLATION
USE ONLY ON GFCI PROTECTED RECEPTACLES CAUTION
WARNING: FAILURE TO FOLLOW THESE INSTRUCTIONS
COULD RESULT IN SERIOUS INJURY OR DEATH. ADULT SET-
UP AND SUPERVISION REQUIRED.
DANGER - TO PREVENT ELECTRIC SHOCK, DO NOT IMMERSE
IN WATER. WIPE CLEAN WITH DAMP CLOTH.
LISTED
E230679
motor and unplug
it from the outlet.
Move the blower
to dry ground if
it appears that it
will get wet from
draining water.
1
Re-stake the bouncer and
the blower, then reconnect and
power up the blower.
Once bouncer is completely dry,
unplug it from the outlet.
5
7
WARNING: Failure to follow these instructions could
result in serious injury or death.
!
WARNING
Electrocution Hazard- DO NOT USE
EXTENSION CORDS WITH THIS PRODUCT.
Cautionary statements should be read before beginning assembly.
ADULT SET-UP AND SUPERVISION REQUIRED.
Use only with Ground Fault Circuit Interrupt (GFCI) receptacle.
This blower is for residential use only. It is not intended to be used in commercial or
industrial settings.
Never insert ngers, pencils or any other object through the grill at ANY time.
Do not operate blower with a damaged cord or plug, after the appliance malfunctions
or has been dropped or damaged in any manner.
Do not operate in the presence of explosive and/or ammable fumes.
Never connect the blower to any solid - state speed control device.
To reduce the risk of re or electric shock, do not use this blower with any solid-state
speed control device.
WARNING - Electronic hazard - Do not use extension cords with this product.
Outdoor use only.
Change the water of the pool frequently (particularly in hot weather) or when
noticeably contaminated.
Children can drown in very small amounts of water. Empty the pool when not in use.
Do not install the pool over concrete, asphalt or any other hard surface.
ON
OFF
ON
OFF
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Little tikes 486159 Racing Slides Waterpark at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Little tikes 486159 Racing Slides Waterpark in the language / languages: English as an attachment in your email.

The manual is 0.66 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info