605544
28
Zoom out
Zoom in
Previous page
1/30
Next page
26
trackIng (centerIng) an exIStIng or new StrIDIng beLt
1. Locate the two access holes to the BELT TENSIONING BOLTS on each of the rear roller guards. These tensioning
bolts make it possible to adjust tracking and centering of the striding belt without removing the guards.
2. Stand on the sides of the treadmill and straddle the belt. Enter the MANUAL
Workout and set the belt speed to run at 4.0 mph (6.4 kph).
3. If the striding belt has moved to the right, turn the right tension bolt 1/4 turn
clockwise with the provided 6MM Hex Key Wrench, and then turn the left
tension bolt 1/4 turn counter-clockwise to start striding belt tracking back to
center of roller.
4. If the striding belt has moved to the left, turn the left tension bolt 1/4 turn
clockwise and then turn the right tension bolt 1/4 turn counter-clockwise to
tart striding belt tracking back to center of roller. Repeat adjustments until the striding belt appears centered. Allow the
machine to continue running for several minutes to observe if tracking remains stabilized.
Note: Do not exceed one full turn of the adjusting screws in either direction. If after one full turn the belt does not track
properly, contact Customer Support Services.
tenSIonIng an exIStIng StrIDIng beLt
Under normal usage, the treadmill striding belt may stretch slightly. If the belt starts to slip during use, take the steps listed
below to correct the tension.
1. Using the STOP key, stop the treadmill.
2. Turn the belt tensioning bolts clockwise a quarter-turn per side to tension the belt. Do not exceed one full turn (four
quarter-turns per side).
3. Set the treadmill at 2.0-mph (3.2 kph) and get on to make sure the belt no longer slips. Also, check the striding belt’s
tracking. If the striding belt drifts to the left or right see Tracking (Centering) an Existing or New Striding Belt.
Note: Do not overtighten the tensioning bolts while making belt adjustments. Overtightening of bolts may over stretch
and damage the striding belt or roller bearings. Do not exceed one full turn of either bolt in either direction.
7.4 uSIng anD teStIng tHe Safety Stop puLL corD
During operation of the treadmill, the lanyard on the Safety Stop Pull Cord should be attached to an item of the user’s
clothing. While the treadmill is on and the console display is active, remove the Safety Stop Pull Cord from the treadmill. A
message shall be displayed on the console similar to “EMERGENCY STOP - REPLACE KEY”. With the Safety Stop Pull
Cord removed no keys shall function on the treadmill.
Place the Safety Stop Pull Cord back in place. The treadmill will reset and will be ready for operation.
7.5 How to obtaIn proDuct ServIce
1. Please contact your dealer or Life Fitness Customer Support Services at 1-800-351-3737.
2. Verify the symptom and review the operating instructions and troubleshooting matrix.
3. Locate and document the serial number of the treadmill. The treadmill’s serial number is located on the front of the
treadmill near the power switch. Please also have proof of purchase information available.
28


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Life Fitness T5 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Life Fitness T5 in the language / languages: English as an attachment in your email.

The manual is 4,9 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Life Fitness T5

Life Fitness T5 User Manual - German - 28 pages

Life Fitness T5 User Manual - Dutch - 27 pages

Life Fitness T5 User Manual - French - 27 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info