597669
7
Zoom out
Zoom in
Previous page
1/8
Next page
13
EN
Shutting your appliance down
If your appliance is to be shut down for any length of time, switch
it o and disconnect the plug or switch o or unscrew the fuse.
Clean the appliance and leave the door open in order to prevent
unpleasant smells.
The appliance complies with the relevant safety regulations and
EU Directives 2014/30/EU and 2014/35/EU.
Interior light
The interior light will always switch on when the appliance door
is opened.
Press the Light button if you want the interior light to be
on even when the door is closed.
Furthermore, the brightness of the lighting can be adjusted.
Press the Light button.
Press and hold the Light button
and at the same time press the
temperature setting buttons to in-
crease or decrease the brightness.
The light intensity of the LED light corresponds to laser
class 1/1M.
Important
The light cover may only be removed by customer service
sta.
If the cover is removed, do not look directly at the light
through optical lenses from close distance. This can dam-
age your eyes.
Air exchange with activated charcoal lter
The way in which wines continue to mature depends on the ambient
conditions. The quality of the air is therefore decisive for preserv-
ing the wine. We recommend that you replace the illustrated lter
once a year. Filters can be obtained from your dealer.
Changing the lter:
Take the lter by the handle.
Turn it 90° to the left or right
and remove.
Inserting the lter:
Insert with the handle in a verti-
cal position. Turn it 90° to the left
or right until it clicks into place.
Saving energy
- Always ensure good ventilation. Do not cover ventilation open-
ings or grille.
- Always keep fan louvres clear.
- Do not place appliance in areas of direct sunlight or next to a
stove, heater or similar object.
- The energy consumption depends on the installation conditions,
e.g. the ambient temperature.
- Keep the time the appliance is open to a minimum. Cleaning
B e f o r e c l e a n i n g , a lw a ys s wi t c h o t h e a p p l i a n c e . D i s c o n n e c t
from the mains or switch o or unscrew the fuse.
Clean the inside and outer walls with lukewarm water and a lit-
tle detergent. Do not use abrasive or acid cleaners or chemical
solvents.
Use a glass cleaner to clean the glass surfaces and a commercially
available stainless-steel cleaning agent for the stainless-steel
surfaces.
Do not use steam cleaners because of the
risk of injury and damage.
Ensure that no cleaning water penetrates into the elec trical
components or ventilation grille.
Do not damage or remove the type plate on the inside of the
appliance. It is very important for servicing purposes.
Malfunctions
F1 appears in the display.
The appliance has suffered a fault. Contact the customer service
department.
You may be able to rectify the following faults by checking
the possible causes yourself.
Appliance does not function:
Is the appliance switched on?
Is the plug correctly fitted in the mains socket?
Is the fuse intact?
When inserting the mains plug, the refrigeration unit does
not switch on, but a value is shown in the temperature
display.
Demo mode is activated. Contact the customer service depart-
ment.
Loud running noise:
Is the appliance set up firmly on the floor?
Does the appliance cause nearby items of furniture or objects to
vibrate? Please note that noises caused by the refrigerant circuit
cannot be avoided.
The temperature is not low enough:
Is the temperature setting correct (see "Setting the temperature")?
Does the separately installed thermometer show the correct
reading?
Is the ventilation system working properly?
Is the appliance set up too close to a heat source?
If none of the above causes
apply and you cannot rectify
the fault yourself, contact the
nearest customer service de-
partment stating the type des-
ignation (1), service number (2)
and appliance number (3) as
indicated on the type plate.
The position of the type plate is shown in the section entitled
Description of the appliance.
Lighting
Class1Light source
This product contains a light source that
meets energy eciency rating G LED
1 The appliance may contain light sources with dierent energy
eciency classes. The lowest energy eciency class is
indicated.
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Liebherr WKEes 553 GrandCru at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Liebherr WKEes 553 GrandCru in the language / languages: English as an attachment in your email.

The manual is 2.02 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Liebherr WKEes 553 GrandCru

Liebherr WKEes 553 GrandCru User Manual - German - 8 pages

Liebherr WKEes 553 GrandCru User Manual - Dutch - 7 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info