465366
24
Zoom out
Zoom in
Previous page
1/26
Next page
Setting the water intake time
The opening time of the IceMaker valve can be adjusted if, for
example, the water pressure in the line is too low or too high. The
water intake time is adjustable in steps from E1 (short intake time)
to E8 (long intake time).
u
To activate the setting mode: press the SuperFrost button
Fig. 3 (11)
for about 5 s.
w
The display indicates c.
w
Themenu symbol
Fig. 3 (15)
shines.
u
Using the Up setting button, freezer compartment
Fig. 3 (8)
and Down setting button, freezer compartment
Fig. 3 (9)
se-
lect E.
u
To confirm: briefly press the SuperFrost button
Fig. 3 (11)
.
u
To increase the water intake time:
press the Up setting button, freezer
compartment
Fig. 3 (8)
.
u
To reduce the water intake time: press
the Down setting button, freezer com-
partment
Fig. 3 (9)
.
u
To confirm: press the SuperFrost but-
ton
Fig. 3 (11)
.
u
To deactivate the setting mode: press the On/Off button,
freezer compartment
Fig. 3 (10)
.
-or-
u
Wait for 2 minutes.
6 Maintenance
6.1 Defrosting with NoFrost
The NoFrost system automatically defrosts the appliance.
BioFresh compartment:
The defrost water evaporates due to the compressor heat. Drops
of water on the rear wall are perfectly normal.
Freezer compartment:
The moisture condenses on the evaporator, is periodically de-
frosted and evaporates.
u
The appliance does not have to be manually defrosted.
6.2 Cleaning the appliance.
Before cleaning:
CAUTION
Risk of injury and damage as a result of hot steam!
Hot steam may damage the surfaces and cause burns.
u
Do not use any steam cleaners!
NOTICE
Incorrect cleaning damages the appliance!
u
Do not use cleaning agents in concentrated form.
u
Do not use any scouring or abrasive sponges or steel wool.
u
Do not use any cleaning agents containing sand, chloride,
chemicals or acid.
u
Do not use chemical solvents.
u
Do not damage or remove the type plate on the inside of the
appliance. It is important for the customer service.
u
Do not pull off, bend or damage cables or other components.
u
Do not allow any cleaning water to enter the drain channel,
ventilation grille or electrical parts.
u
Empty the appliance.
u
Pull out the plug.
- Use soft cleaning cloths and a multi-purpose clean-
ing agent with neutral pH value.
- Only use food compatible cleaning and care agents
on the inside of the appliance.
Outside surfaces and interior:
u
Regularly clean ventilation grilles.
w
Dust deposits increase energy consumption.
u
Clean the plastic surfaces, outside and inside, by hand using
lukewarm water and a little washing-up liquid.
NOTICE
The stainless steel doors have a high-quality surface coating and
must not be cleaned with the accompanying care product.
Otherwise the surface coating will be affected.
u
Wipe the coated door surfaces using a soft, clean cloth only.
In case of stubborn dirt, use a little water or a neutral cleaning
agent. A microfibre cloth can be optionally used.
u
If the stainless steel side walls are dirty, clean them using
a commercially available stainless steel cleaning agent. Then
evenly apply the accompanying stainless steel care product,
making strokes in the direction of the grain.
u
Wipe side walls with a paint finish using a soft, clean cloth
only. In case of stubborn dirt, use a little water or a neutral
cleaning agent. A microfibre cloth can be optionally used.
Clean stainless steel surfaces with a standard stainless steel
cleaning agent. Darker areas at the beginning and quite an in-
tensive colour of the stainless steel surface are normal.
u
Do not apply cleaners to glass or plastic surfaces so as not to
scratch them.
u
To clean the drain opening: remove any
deposits with a fine instrument, e.g. a cot-
ton bud.
Items of equipment:
u
Clean items of equipment by hand with lukewarm water and
a little washing-up liquid.
u
For cleaning, remove the support rails for the half-sized glass
shelves.
After cleaning:
u
Wipe dry the appliance and items of equipment.
u
Connect the appliance and switch it on again.
u
Switch on SuperFrost (see 5.7.4) .
When the temperature is sufficiently cold:
u
Put the food back inside.
6.3 Cleaning the IceMaker
The drawer of the IceMaker has to be emptied and slid in.
u
To activate the setting mode: press the SuperFrost button
Fig. 3 (11)
for about 5 s.
w
The display indicates c.
w
The menu symbol
Fig. 3 (15)
shines.
u
Using the Up setting button, freezer compartment
Fig. 3 (8)
/ Down setting button, freezer compart-
ment
Fig. 3 (9)
select Ic.
u
To confirm: press the SuperFrost button
Fig. 3 (11)
.
w
The IceMaker moves into the cleaning position and switches
off.
u
To deactivate the setting mode: press the On/Off button,
freezer compartment
Fig. 3 (10)
.
-or-
u
Wait for 2 minutes.
w
The temperature is indicated again in the temperature display.
u
Remove the drawer.
u
Clean the ice cube tray and drawer with warm water. If nec-
essary, use mild washing-up liquid. Then rinse.
u
Slide in the drawer again.
Maintenance
12
24


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Liebherr K 3620 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Liebherr K 3620 in the language / languages: English as an attachment in your email.

The manual is 1,05 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Liebherr K 3620

Liebherr K 3620 User Manual - Dutch - 10 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info