495977

Liebherr CUP2901 Manual

6
Zoom out
Zoom in
Previous page
1/8
Next page
12
- Is the appliance switched on?
- The bulb is defective. Change the bulb as described in "Inte
-
rior light".
Interior light on when Cool-Plus activated:
- This is necessary from a technical point of view and is
quite normal.
- To be able to ensure that the Cool-Plus function works en
-
tirely as it should, the defective light bulb should be replaced
as soon as possible.
Appliance does not work:
Your appliance is designed and manufactured for a long life
span and reliable operation.
If a malfunction nonetheless occurs during operation, check
whether it is due to an operating error. Please note that even
during the warranty period the resultant servicing costs in this
case will have to be borne by the owner.
You may be able to rectify the following faults by checking the
possible causes yourself:
Malfunction Possible cause and remedy
5 Troubleshooting
Loud running noise:
- Is the appliance standing firmly on the floor, or does the
compressor cause nearby items of furniture or objects to
vibrate? If necessary, move the appliance slightly, align by
adjusting the adjustable feet, or move bottles and containers
apart.
- Burbling noises are normal. These are caused by the refriger-
ant flowing round the refrigerant circuit.
A short
clicking sound: This will be heard whenever the refrig-
eration unit (the motor) switches on or off automatically.
Motor noise: This will be slightly louder for a brief period
when the refrigeration unit switches on.
The temperature is not cold enough:
- Is the temperature setting correct? If necessary, set a lower
temperature.
- Loose thermometer in appliance is showing a wrong reading.
- Does the door close properly?
- Is the appliance sufficiently well ventilated? Clear ventilation
grilles if necessary.
- Is the ambient temperature too hot? (See "Safety regulations")
- Has the appliance been opened too often or left open too long?
- If applicable, wait until the appliance reaches the required
temperature itself.
Customer service and type plate
If none of the above causes apply and you cannot
rectify the fault yourself, please contact your nearest
customer service department (see enclosed list for
addresses). State the type designation 1, service number
2 and appliance number 3 as given on the type plate, so
as to ensure rapid, accurate servicing. The type plate is located
inside the appliance on the left-hand side.
- Is the appliance switched on properly?
- Is the mains plug properly inserted in the socket?
- Is the socket fuse intact?
The interior light does not come on:
4 Defrosting, cleaning
Defrosting
The refrigerator compartment
defrosts automatically. The defrost water is evaporated
by the heat from the compressor; drops of water on the
rear wall are perfectly normal.
W Ensure that the defrost water can flow freely through the
drain hole in the rear wall (arrow in fig. A).
The freezer compartment
W To defrost, switch off the appliance:
- Disconnect the appliance from the mains or
- set the temperature control to "0".
W If possible, put the frozen goods in the freezer drawer, wrap
in newspaper or a blanket and store in a cool place.
W To speed up the defrosting process place a saucepan of hot
but not boiling water on one of the middle shelves.
Do not use electric heaters or steam clean-ers, defrost
-
ing sprays or naked flames for defrosting nor any metal
objects for removing the ice. Risk of injury and damage!
W Leave the appliance door open when defrosting.
After defrosting, mop up the remaining water with a sponge
or cloth and clean the appliance.
Cleaning
W Before cleaning, always switch off the appliance.
Disconnect from the mains or un-screw or switch
off the fuse.
W
Wash shelves, glass plates and other options by
hand.
W Clean the outer walls, inside and equipment by hand with
lukewarm water and a little detergent. Because of the risk of
injury and damage to the appliance, steam cleaning equip-
ment should not be used.
W Do not use abrasive sponges or scourers, do not use
concentrated cleaning agents and never use cleaning
agents containing sand, chloride or acid or chemical sol-
vents, as these would damage the surfaces and could
cause corrosion.
W We recommend using a soft cloth and an all-purpose
cleaner with a neutral pH value. Only use food safe cleaning
materials inside the appliance.
W For stainless-steel appliances*:
- Clean the side panels and door surfaces with a clean and
soft cloth. If necessary, use a moist cloth (water + deter-
gent). Alternatively, use a micro-fibre cloth.
W Ensure that no cleaning water penetrates into the electrical
components, drain gulley* or ventilation grilles.
Wipe the appliance dry.
W Do not damage or remove the type plate on the inside of the
appliance. It is very important for servicing purposes.
W Clean the drain hole on the rear wall above the vegetable
bins frequently, fig. A, arrow.
If necessary, clean with a thin object, e.g. a cotton
swab or similar.
W Ensure that none of the wires or other components are dis-
lodged, bent or damaged.
W Then connect/switch on the appliance.
If the appliance is to be left switched off for any length of
time, empty the appliance, disconnect from the mains, clean
as described above and leave the door open so as to avoid
odours.
* Depending on model and options
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Liebherr CUP2901 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Liebherr CUP2901 in the language / languages: English as an attachment in your email.

The manual is 1,37 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Liebherr CUP2901

Liebherr CUP2901 User Manual - Dutch - 8 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info