Manual Liebherr CBNPes 4656 (page 9 of 11) (English)

611590

Zoom out

Zoom in

1/11

Defrosting

Refrigerator compartment

The refrigerator compartment defrosts automatically. The water that

forms on the rear wall drains into a reservoir at the back of the appli-

ance and evaporates automatically through the compressor heat.

Freezer compartment

The NoFrost system automatically defrosts the appliance.

Any moisture arising collects on the evaporator and freezes, and

is periodically defrosted and evaporated.

Malfunctions

You may be able to rectify the following faults by checking

the possible causes yourself:

• Appliance does not function:

– Is the appliance switched on?

– Is the plug correctly fitted in the mains socket?

– Is the fuse intact?

• Loud running noise:

– Is the appliance set up firmly on the floor?

– Does the appliance cause nearby items of furniture or objects to

vibrate? Please note that noises caused by the refrigerant circuit

cannot be avoided.

• The temperature is not low enough:

– Is the temperature setting correct (see "Setting the temperature")?

– Have excessive amounts of fresh food been placed in the appli-

ance?

– Does the separately installed thermometer show the correct read-

ing?

– Is the ventilation system working properly?

– Is the appliance set up too close to a heat source?

If none of the above causes

apply and you cannot rectify

the fault yourself, contact the

nearest customer service de-

partment stating the type des-

ignation

1, service number 2

and appliance number

3 as

indicated on the type plate.

The position of the type plate is shown in the section entitled

Description of the appliance.

Installing appliance in a row of kitchen units

To adapt the height of the appliance to the surrounding furniture

a top unit

1 can be added.

A gap of at least 50 mm

depth must be provided

behind and along the entire

width of this unit so as to

ensure sucient ventila-

tion. The area of ventila-

tion underneath the ceiling

should be at least 300 cm

When setting up the ap-

pliance next to a wall

4, a

distance of approx. 50 mm

must be provided on the

hinge side between the

appliance and the wall (for

the handle when the door

is open).

1 top unit

2 refrigerator-freezer

3 kitchen unit side panel

4 wall

Shutting your appliance down

If your appliance is to be shut down for any length of time, switch

it o and disconnect the plug or switch o or unscrew the fuse.

Clean the appliance and leave the door open in order to prevent

unpleasant smells.

The appliance complies with the relevant safety regulations and

EC Directives 2004/108/EC and 2006/95/EC.

Cleaning

Before cleaning, always switch o the appliance. Disconnect

from the mains or switch o or unscrew the fuse.

• First clean the side panels with a conventional stainless steel

cleaner. Subsequently, apply the enclosed stainless steel care

product evenly onto the surfaces in the same direction in with

they have been ground or polished.

• Only clean the door surfaces with a clean and soft cloth. If neces-

sary, moisten the cloth (water + detergent). Alternatively, use a

micro-fibre cloth.

- Do not use abrasive sponges or scourers, do not use concentrated

cleaning agents and never use cleaning agents containing sand,

chloride or acid or chemical solvents, as these would damage the

surfaces and could cause corrosion.

• Clean the inside and equipment parts with lukewarm water and

a little detergent.

Do not use steam cleaners because of the risk

of injury and damage.

• Ensure that no cleaning water penetrates into the electrical com-

ponents or ventilation grille.

• Dry all parts well with a cloth.

• Do not damage or remove the type plate on the inside of the ap-

pliance. It is very important for servicing purposes.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Liebherr CBNPes 4656 in the language / languages: English as an attachment in your email.

The manual is 1,35 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Liebherr CBNPes 4656

Liebherr CBNPes 4656 User Manual - German - 11 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Liebherr CBNPes 4656 Manual

Product: