455801
6
Zoom out
Zoom in
Previous page
1/9
Next page
- 5 -
Dimmer Control
The display
DIMMER
selector switch located on the
right
side cabinet was set to the
HIGH
position at our
factory.
If you find the display to be too bright for sleeping, slide the
DIMMER
selector
switch to the
LOW
position
.
Sleep To Music Timer
You can use the sleep timer to fall asleep to the Radio, CD player or USB/SD/MMC music up to 90
minutes
and have the unit shut off automatically.
1)
Press the ALARM OFF/POWER button to turn the power On . Operate the
Radio
, USB/SD/MMC
music or
CD player as usual. Adjust the
VOLUME
to the desired level.
WARNING:
The
level you select for Sleep To Music is the same level you will hear when the alarm turns
On in the morning.
2)
Press the
SLEEP
button to select the desired amount of sleep timer from 90 minutes to one minute. The
SLEEP
indicator comes On .
3)
When the display shows the desired amount of time, stop pressing the
SLEEP
button.
After 5 seconds the
display changes back to the correct time. The Radio, CD player or USB/SD/MMC music will continue
until the sleep timer counts down to 00
and then shut off automatically.
4)
To stop the Radio or CD player before the sleep timer counts down to 00 , press the
ALARM
OFF/
POWER
button to turn the unit Off .
Note
: If you are falling asleep to
CD
or USB/SD/MMC, the sound stops when the disc ends, even if a longer
sleep time was selected.
Listening To The Radio
1)
Press the
ALARM OFF/POWER
button to turn the unit On .
The
POWER
LED indicator comes on.
2)
Press the
FUNCTION
button
until the
FUNCTION
i
ndicator turns off
to select the Radio function.
3)
Rotate the
TUNING
control on the right side panel to tune to the desired station. Press the ST/MONO
button if the received program is too noisy.
4)
Rotate the
VOLUME
control on the left side panel to adjust the
volume level.
5)
When you are finished listening press the ALARM OFF/POWER button to turn the unit Off . The
POWER
LED indicator goes off.
FM
Antenna
Wire
Make sure the FM lead wire antenna is extended to it s full length. You may have to vary the directio
n of the
wire antenna to find the position that provides the best
reception.
Playing C
D
/MP3 Di
scs
NOTE:
Although this CD
/MP3
player can read CD-R and CD-RW discs, in addition to normal CD
/MP3
,
however the playability of CD-R/RW discs may be affected by
th
e type of software that was used to create
the discs, as well as the quality and condition of the blank media you are using. 100% playability cannot be
guaranteed. This is not an indication of a problem with the player.
Normal Playback
1)
Press the ALARM OFF
/POWER
bu
tton to switch the unit On . The
POWER
LED indicator comes
On .
2)
Press the
FUNCTION
button until the
FUNCTION
indicator turns on
red
to enter CD playing mode.
shown on display.
3)
Press on the CD door in the area marked
OPEN/CLOSE
to open the doo
r. If
you have not already done so,
remove the dummy CD transit protection card
from the CD player and discard it
.
4)
Place your disc on the center spindle with the printed label side facing up. Press down near the center of
the disc to make sure it is firm
ly seated on the
spindle, press
OPEN/CLOSE
area to close the CD door.
5)
The display will show
flashing, t
he
n the total number of tracks will appear on the display for a
few seconds and start playback from the first track. The display returns to the correct time after several
seconds
.
To see the track number at any time during playback press the
DISPLAY
button.
Note:
If the disc is inserted incorrectly, or if the disc is badly scratched and cannot be read by the
player,
- - - - will appear on the
display for a
few seconds, and then the display
returns to the correct time.
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Lenco CR 2800 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Lenco CR 2800 in the language / languages: English as an attachment in your email.

The manual is 0,45 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info