719432

Lanaform LA120209 Manual

4
Zoom out
Zoom in
Previous page
1/28
Next page
English 4 / 28
EN FR NL DE ES IT CS SL HR
Note
When it is rst used, all the LEDs will light
up to begin with. The air purier is set at the
lowest ventilation speed.
When the “Filter Reset” light above
the
stop
/
start
button ashes, change the
combined lter.
To do this, follow the instructions in the chap-
ter on “Changing the lter”.
Ventilation speed
The air purier has four ventilation speeds:
I (low), II (average), III (high) and IV (turbo)
To move from one ventilation speed to an-
other, press the ventilation speed button
The
ventilation speed
indicator as currently con-
gured will light up on the control panel.
UV light/Night Mode
Press this button once to switch on the UV
light.
Press the button a second time to switch on
standby mode. The indicator will light up
 times before all the indicators switch o.
Press any button to switch on the machine
and standby mode will switch o.
Press this button a third time to switch o
the UV light. The standby mode indicator
will ash  times and standby mode is then
switched on again.
Then press this button again to switch o
standby mode.
Timer function
The air purier has a timer function with
which you can decide on the number of hours
after which the device must stop. The air pu-
rier has three timer periods: hrs (two hours),
hrs (four hours) and hrs (eight hours).
To move from one timer speed to another,
press the
timer
button. The timer length in-
dicator as currently congured will light up
on the control panel. The air purier then
switches o automatically after the number
of hours dened.
To switch o the timer, press the
timer
button
until no light is lit above the button. The air
purier will then run with no time limit.
Changing the air lter
You must replace the three-layer lter after
, hours of use. The red “Filter Reset” LED
above the
stop
/
start
button ashes after ,
hours of use. To replace the lter, proceed
as follows:
• Turn the purier upside down.
•
Unscrew the bolt under the base followed
by the base.
•
Remove the dirty lter and insert the new
lter into the device.
Put the base back in place and x it using
the fastening nut.
Replacing the UV light
The UV light has a life of , hours.
• Unscrew the UV light’s holder:
•
Gently remove the cover and unscrew
the UV light.
• Insert a new UV light then put the cover
back on.
•
Note: Do not look at the UV light when
it is lit.
TROUBLESHOOTING
Impossible to switch on
the air purier.
The casing cover has not
been installed properly.
Make sure that the casing cover
is in the right position.
The three-layer lter has not
been installed properly.
Make sure that the three-layer
lter is the right position.
The mains adapter is not connected.
Plug the mains adapter into
a suitable power socket.
There is insucient throughput of air
The lters are clogged.
Clean the lters (see the chapter
on “Maintenance and Storage”.
The air inlet/exhaust is blocked
Make sure that the air inlet/
exhaust is not blocked.
The air purier is very noisy.
There is a foreign body in
the air inlet/exhaust.
Remove the foreign body from
the air inlet/exhaust.
The lters are clogged.
Clean the lters (see the chapter
on “Maintenance and Storage”).
The lters are not installed properly.
Reposition the lters correctly.
The air purier is standing on
a very uneven surface.
Put the air purier on a at surface.
MAINTENANCE
Install the air purier
Before cleaning the device, check that the air
purier’s power supply is fully disconnected.
Clean the air purier’s casing with a slightly
damp cloth (with water or a gentle cleaning
solution). Do not use thinner or other corro-
sive or abrasive cleaning products because
the surface might get damaged.
Clean the lter
Only the pre-lter is washable. Check that
it is dry before xing to the HEPA lter and
activated carbon lter.
The lter needs to be cleaned regularly (once
a month) for ecient and hygienic use. Clean
the three-layer lter with the nozzle of a
vacuum brush. For a full clean, remove the
pre-lter, then clean the carbon lter and the
HEPA lter with the nozzle of a vacuum brush.
Then replace the pre-lter on the HEPA lter.
The three-layer lter must be replaced after
, hours of use (see chapter on “Changing
the air lter”).
STORAGE
If you do not use the device for a prolonged
period, we recommend that you store it once
cleaned in its original packaging and do not
put anything on top of it.
TECHNICAL DATA
Model LA
Voltage -V
Power W
Dimensions  × ×  mm
Weight .kg
Covered surface ±m²
Conditions
of use
+°C a +°C, ≤ relative air
humidity (non-condensing)
Safety category
Safety category II /
CADR m³/hr
UV light Wave length:  nanometres
Light lifespan: Approx. , hours
HEPA lter
+ Activated
carbon lter
E HEPA lter
HEPA lter + Activated carbon
Filter lifespan: h
Sound level Level  <dB; Level  <dB;
Level  <dB; Turbo <dB
ADVICE ON WASTE
DISPOSAL
The packaging consists entirely of environ-
mentally-friendly materials that can be taken
to your local waste sorting centre to be used
as secondary materials. Cardboard can be
placed in a paper collection container. Pack-
ing lm must be taken to your local sorting
and recycling centre.
When you are no longer using the device, dis-
pose of it in an environmentally responsible
manner and in compliance with the statutory
requirements.
LIMITED WARRANTY
LANAFORM guarantees that this product will
be free from any material and workmanship
defects for a period of two years from the
date it was purchased, other than as spec-
ied below.
The LANAFORM warranty does not cover
damage caused by normal wear and tear on
this product. In addition, the warranty on this
E-IM-AirPurifier-001.indd 4 15/06/2018 11:57:17
… 4 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Lanaform LA120209 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Lanaform LA120209 in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 2,98 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info