719426

Lanaform LA120124 Manual

5
Zoom out
Zoom in
Previous page
1/36
Next page
5 / 36 English
EN FR NL DE ES IT PL CS SK SL HR BG
outlet pipe [
]. Make sure that this and
the closing cover of the mist outlet pipe [
] are in the right position. [
]
Adjusting the mist intensity
Press the touch control button [
1
16] re-
peatedly to adjust the emission of cool mist:
•
press once: maximum intensity is selected
(approximately 150 ml/hr). The LED indica-
tor
[
1
15]
under the symbol “H” lights up.
•
Press twice: minimum intensity is selected
(approximately 120 ml/hr). The LED indica-
tor [
1
15] under the symbol “L” lights up.
•
Press 3 times: the humidier runs on
“night” mode. The white atmospheric light
is then disabled and the light indicator
[
1
15]
“
” goes out after 3 seconds.
When there is no water left in the reservoir,
the humidier stops and the indicator dis-
plays red for  seconds. You can also stop it
at any time by pressing a fourth time on the
touch control button.
Light settings
When the device lights up, it does not emit
any atmospheric light by default.
•
Press the button that chooses the light
mode [
1
17] once: a warm white light
is activated.
•
Then press the button that selects the light
mode [
1
17] repeatedly to change the
temperature of the white light to a neutral
then cool white light.
•
Press a fourth time and the light will go out.
Important notes
• Use only clean distilled or demineralised
water in order to avoid any malfunction.
•
Do not pour water into the exhaust pipe
[
1
10]
to prevent any dysfunction and re risk.
• Make sure you close the reservoir lid [
1
1] hermetically.
• The reservoir must be kept clean. If there
is any dirt on the vapour emission diuser
sprinkler tip, clean it with a brush or a
damp cloth.
Please note: even though there
is a safety device that stops the
transducer from working, do
not leave the device connected
when you are not using it.
Additional information about
the use of essential oils:
Before using essential oils, please check the
harmful eects that use of these products
may have on your health.
Always choose quality essential oils that are
pure,   natural and intended for diusion.
Use them in moderation and with care. Follow
the instructions and warnings stated on the
packaging of the essential oils, in particular
noting that:
•
Pregnant women, people with epilepsy,
asthmatics and people who suer from
allergies, those with heart problems or se-
rious illnesses should not use essential oils.
•
Essential oils should be used only for peri-
ods not exceeding 10 minutes in the room
of a baby (under 3 years old) and only
when the baby is not actually in the room.
•
Make sure that children and minors do
not play with or use the device.
• Just a few drops (3 to 4 drops at most) of
essential oils are sucient to ensure that
the device works properly and the scent
is diused. Excessive use of essential oils
could damage the device.
•
Make sure you pour water into the res-
ervoir rst before adding the drops of
essential oils.
•
Lanaform cannot be held liable in the
event of accidental damage resulting from
any use contrary to the instructions given
in these instructions for use.
MAINTENANCE AND STORAGE
Always switch o the humidier before per-
forming any maintenance or storage activities.
If the water contains too much calcium and
magnesium, it may deposit a white powder
in the device. If this foam is deposited on
the transducer [
1
] , this will prevent the
Dobra humidier from working properly.
Maintenance
We recommend
1 using clean distilled, demin-
eralised or boiled water each
time the device is used.
2 Cleaning the reservoir every 2 days and
cleaning the transducer every week.
3 Cleaning the device (see expla-
nations below) and making sure
that all of its parts are complete-
ly dry when it is not in use.
To clean the reservoir [
1
7]
1 Clean the basin with water using
a soft cloth, and use vinegar
if there are any foam or limes-
cale deposits on the inside.
2 Rinse the basin in clean water.
To clean the transducer [
1
11]
1 Place 2 to 5 drops of vinegar on its
surface and leave for 2 to 5 minutes.
2 Brush the foam o the surface
using a soft brush. Do not use a
hard tool to scrape the surface.
3 Then rinse the reservoir in clean water.
Do not use soap, solvent
or spray cleaner to clean
the transducer.
To clean the mist outlet
pipe [
1
3]
1 Remove the unit’s reservoir cap [
1
].
2 Turn the reservoir lid [
1
1] in
an anti-clockwise direction.
3 Remove the mist outlet pipe cap
as well as the ring. [
1
4 & 5]
4 Clean it all with a brush or damp cloth
and vinegar if there are any foam or
limescale deposits on the inside.
5 Position the ring and the mist
outlet pipe cap again as indi-
cated on diagram [
].
6 Close the reservoir cap by turning it in
an anti-clockwise direction, making sure
that the notches are correctly inserted
into those of the mist outlet pipe.
To clean the diuser
nozzle of the device [
1
2]
1 Clean it with a brush or damp cloth.
2 Rinse the vapour emission
sprinkler tip in clean water.
Storage
If you do not intend using the device for a
lengthy period, store the clean, dry humidier
in a cool, dry place out of direct light.
TROUBLESHOOTING
In the event of a malfunction under nor-
mal conditions of use, please refer to the
following list.
No operating indicator light, no mist.
No voltage, no current.
Check whether the device is connected
and that there is no mains fault.
Red indicator light ashing
 times, no mist.
No water in the reservoir.
Pour clean, fresh, distilled or
demineralised water into the reservoir.
The mist has an unpleasant odour.
The device is new.
Drain the water from the reservoir
and leave the reservoir to air
out for at least  hours.
The water is polluted or has been
in the reservoir too long.
Unplug the device, drain the water
from the reservoir, rinse and clean the
reservoir, and ll the reservoir with
demineralised or distilled water.
E-IM-Dobra-LA120124-001-2019-v1.0.indd 5 23/09/2019 09:10:40
… 5 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Lanaform LA120124 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Lanaform LA120124 in the language / languages: English, German, Dutch, French, Italian, Polish, Spanish as an attachment in your email.

The manual is 1,81 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info