522403
15
Zoom out
Zoom in
Previous page
1/17
Next page
15
Follow these steps to set the antenna’s LNB to the
skew angle you noted in the previous step.
a. Turn off and unplug your satellite TV
receiver.
b. Press the power switch on the front of the
interface box to disconnect power from the
TracVision system. Make sure the VOLTAGE
status light goes out.
c. Remove the three #10-32 screws securing the
radome to the antenna. Carefully remove the
radome and set it aside in a safe place.
d. Locate the LNB on the back of the antenna’s
reflector (see Figure 26).
e. Loosen the two wing screws securing the
LNB to the choke feed (see Figure 27).
f. Adjust the LNB, clockwise or counter-
clockwise, until the skew arrow on the LNB
points to the correct skew angle on the choke
feed.
g. Tighten the wing screws to secure the LNB in
place.
h. Reinstall the antenna’s radome. The radome’s
“TracVision” labels should face fore and aft
(see Figure 28). While pressing the radome
down onto the base, secure the radome to the
base using the three #10-32 screws you
removed earlier.
i. Install a protective plastic screw cap
(supplied in the kit) over each radome screw.
CAUTION
Disconnect power from the antenna before
you remove the radome. The antenna has
moving parts that can cause injury.
Reflector
LNB
Figure 26: Location of LNB on Back of Antenna Reflector
+
0
10
20
30
40
50
60
70
10
20
30
40
50
60
70
5
15
25
35
45
55
65
5
15
25
35
45
55
65
Choke Feed
Skew Arrow
Wing Screw
(1 of 2)
LNB
Figure 27: LNB Skew Angle Adjustment
Make sure the LNB is fully inserted into the
choke feed. The shaft of the LNB must be
seated properly against the feed tube to
ensure optimum performance.
IMPORTANT!
Figure 28: Radome Labels Facing Fore and Aft
Set the LNB Skew Angle
13
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for KVH TracVision M2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of KVH TracVision M2 in the language / languages: English as an attachment in your email.

The manual is 2,68 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of KVH TracVision M2

KVH TracVision M2 User Manual - English - 65 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info