564216
11
Zoom out
Zoom in
Previous page
1/13
Next page
13
- Then use the following method:
Unscrew the grid of the percolation head
and clean it (10).
Dissolveg 2 tablespoons of descaler or one
packet of accessory 054 in half a litre (16 oz)
of lukewarm water and pour the mixture
into the empty water tank.
• Set the switch (d) to «I». The indicator light
(d1) will come on.
Once the appliance reaches the appropriate
temperature, the temperature control
indicator light (e) comes on.
Place a container under the percolation
head. Run through about 1/3 of the mixture,
setting the function selector (c) to the
position «
».
Set the switch (d) to «0» and wait 10 to 15
minutes to allow the descaler to take effect.
Then set the switch (d) to « I ».
With the function selector (c) in the position
«
», allow the remainder of the mixture to
run into the container placed under the
percolation head.
• Then reset the function selector (c) to O.
Run two tanks of fresh water through to
rinse the percolation head. To do this:
. fill the tank
. place a container under the percolation
head, reset the function selector (c) to « »
and allow the content of the tank to run
through.
. then set the function selector (c) to O and
the switch (d) to «0».
. replace the grid on the head of the appliance
(see paragraph «Maintenance») (10).
Notes:
In the case of serious scaling, soak the grid of
the percolation head for 5 minutes in 1/3 of
the mixture obtained during the first run-
through.
If necessary, this operation can also be
performed with the steam nozzle:
To do this, dismantle the nozzle as instructed
in the paragraph «Maintenance» and soak
the scaled parts for 5 minutes in 1/3 of the
mixture obtained during the first run-
through. Rinse the various parts thoroughly
before replacing them.
Problems, likely causes and
corrective actions
Problems Probable Corrective
causes actions
Espresso not The accessories Pre-heat the
hot enough. are cold accessories
(cups, filter See the paragraph
and filter holder). «Preparing an
espresso».
The appliance is Wait for the
not hot enough. indicator light
(e) to come on.
Leaking coffee The filter holder See paragraph
around the filter is not fitted «Preparing an
holder correctly. espresso».
There is residual Clean around
coffee on the edge the filter and the
of the filter. seal.
The seal of the Clean the seal
percolation head with a damp
is dirty. cloth.
The seal of the Contact an
percolation head is approved KRUPS
defective. service centre.
Very loud noise No water in the Fill the tank.
pump. coming from the
tank.
Tank incorrectly Press firmly on
fitted. the tank
Ground coffee too Use freshly
old or dry. ground coffee.
Water does not No water in the Fill the
flow properly. tank. tank.
Tank badly Press firmly on
fitted. the tank.
The filter is Clean the filter
blocked-the and the grid of
ground coffee is the percolation
too fine or head. See the
compacted paragraph
too tightly. «Maintenance »
and try using a
coarser ground
coffee.
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Krups F920 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Krups F920 in the language / languages: English as an attachment in your email.

The manual is 0,42 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Krups F920

Krups F920 User Manual - Dutch - 6 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info