694598
18
Zoom out
Zoom in
Previous page
1/100
Next page
18
5. Fuel
5.1. Recommended fuel
- the producer recommends to use logs of decidueus trees such as: beech, hornbeam, oak, alder,
birch, ash-tree etc. of the following dimensions of logs or chips: ca. 30 cm long and from 30 cm to 50
cm in circumference and lignite briquette.
- the moisture content of the wood used for ring the appliance should not exceed 20% which corre-
sponds to the wood seasoned for two years after felling, stored under a roof.
5.2. Unrecommended fuel
The appliance should not be red with logs or chips with the moisture content exceeding 20% as it
may result in failure to achieve declared technical parameters - lower caloric value.
It is not recommended to use too small logs or chips to re the appliance as it may result in sudden
increase of water temperature - boiling of water as well as signicant increase of ue gas temperature
and re of the chimney.
It is not recommended to use coniferous or resinous wood logs or chips since they cause excessive
dirt of the appliance and necessity of frequent cleaning of the appliance and the chimney ue.
5.3. Prohibited fuel
It is prohibited to burn in the appliance any waste, particularly chemical one, due the emission of
toxic substances in the process of burning.
6. Working principle
6.1. Fire-up and fuel charge
a) Open the starting damper (13) with a knob (15);
b) Open the door (2) with a bolt (4);
c) Open to the maximum the air throttle with a handle (9);
d) Put some paper or special tinder on the grate (10), place small twigs, than bigger pieces of ca. 3-5
diameter,
e) Ignite the paper and close the door (2),
f ) Once the tinder is red up close the damper (13),
g) When the heat re-up layer (ca. 2cm thick) is ready, ll up the hearth with appropriate fuel. Each
time when you ll up the hearth with fuel remember to do as follows:
- open the starting damper (13),
- set ajar and then open the door (2) gently,
- in needed remove ash and ll the hearth up with fuel, - close the door(2),
- once the fuel is ignited, close the starting damper (13);
h) The desired burning intensity is obtained by controlling the primary air throttle by means of the
handle (9),
i) During the rst few hours of the appliance operation future users are recommended to operate
the replace insert with water jacket at low loads of ca. 30-50% of rated load due to too big thermal
stress that may lead to its excessive use and even cause damage to the appliance.
It is not allowed to pour, soak wood with easily combustible liquids like petrol, fuel oil, solvent etc. or
to add these materials to the hearth to speed up the fuel re-up.
Vapours of these liquids are a strong explosive mixture!!!
6.2. Normal operation of the replace insert with water jacket
To re the replace insert with water jacket use the logs or chips of deciduous trees of the following
dimensions: ca. 30 cm long and from 30 cm to 50 cm in circumference or lignite briquette.
To achieve the rated thermal power of the replace insert with water jacket ll up the hearth with 4-5
wood logs and uncover completely the air throttle (9).
To achieve the thermal power that is lower than the rated power ll up the hearth with 3-5 bigger
wood logs and cover the air throttle (9) as needed.
6.3. Operation with minimum power in extended time
The replace insert with water jacket may operate with minimum thermal power and the burning
18


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kratki ZUZIA 19 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kratki ZUZIA 19 in the language / languages: English, German, French, Polish as an attachment in your email.

The manual is 4,63 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info