Manual Konig Electronic SEC-IPCAM105 (page 5 of 190) (All languages)

626631

Zoom out

Zoom in

1/190

APPLE

Set the IP camera to connect to the Wi-Fi router

Open up “Settings” on your iOS device and select “Wi-Fi” and let it search for a network.

The network will be “Wi-Fi-cam-p2p”. Select “Wi-Fi-cam-p2p” to connect.

Now, open the “uCare Cam” app and select the tab at the bottom of the screen that says

“Wi-Fi Connect”.

Select “Router mode”, then “Next”. Enter here the Wi-Fi network name (SSID) and

password of your home router.

After the IP camera receives this information, it will restart. Please wait for it to start up and

connect to your Wi-Fi router. When it successfully connects, the status LED colour will turn

orange. It may take up to 5 minutes.

Then select the camera name in the “uCare Cam” app to connect.

Note: If the status LED colour does not turn orange, please check your Wi-Fi router and

make sure the IP camera is within the signal area of your Wi-Fi router. Then try this setup

again.

If your Wi-Fi router has a WPS (Wi-Fi Protected Setup) button, you can use it to set up the IP camera.

(Must enable WPA/WPA2 encryption in Router). On the Wi-Fi router, you will see a button labelled

“WPS”. It may also be called “QSS” or “AOSS”

Setup Wi-Fi - WPS mode

Open the “uCare Cam” app

and select “Wi-Fi Setting” or “Wi-Fi Connect” at the bottom of the screen.

Select the tab:

then select the tab:

to enter Step 2 (see Figure 8).

Enter WPS mode

Power on your IP camera. The status LED on the IP camera will be green for about 15

seconds.

Programme Loading

The status LED will flash red for about 15 seconds.

Install your IP camera by WPS connection mode

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Konig Electronic SEC-IPCAM105 in the language / languages: All languages as an attachment in your email.

The manual is 2,63 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Konig Electronic SEC-IPCAM105 Manual

Product: