508773
2
Zoom out
Zoom in
Previous page
1/3
Next page
Battery installation:
Alarm:
1. The battery compartment is accessed
from the rear of the alarm by removing the
screws of the mounting bracket.
2. Insert 4x C size batteries (not included)
according the correct polarity
(see figure C)
3. When the batteries are inserted the
alarm will beep very loud to indicate that
the batteries are properly installed.
4. Replace the mounting bracket and fix it
with the screws. The battery LED indicator
will light when the batteries are LOW and
need to be replaced.
Remote control:
The remote control uses 3x LR44 batteries (included). If the red
LED indicator on the remote control does not light up when the
‘ARM’ or ‘DISARM’ buttons are pressed, then the batteries need to
be replaced.
Program alarm:
1. Set the switches (12) of the remote control to the desired code
and remove the batteries from the alarm. Then wait at least 30
seconds for the alarm to reset.
2. Aim, immediately after inserting the batteries, the remote control
at the alarm and press the ‘ARM’ button. The Alarm LED will flash
once to indicate that it has learnt the code of the remote control.
NOTE: the alarm must be programmed again with the remote
control each time the batteries are replaced.
2


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Konig Electronic SEC-APC10 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Konig Electronic SEC-APC10 in the language / languages: English as an attachment in your email.

The manual is 0,48 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Konig Electronic SEC-APC10

Konig Electronic SEC-APC10 User Manual - Dutch - 3 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info